HP G62-234DX RAM Replacement Replacement

Scritto Da: Cameron Popillo
  • Commenti: 0
HP G62-234DX RAM Replacement Replacement

Difficoltà

Easy

Passi

4

Tempo Necessario

15 - 25 minuti

Introduzione

This guide will explain the process to replace the RAM in the HP G62-234DX.

  1. G2MmQkbARqWCHnlX

    • Make sure the computer is turned off, disconnected from the charger, and on a steady surface.

    • Unlock the battery by sliding the button just below it, to the left.

  2. gbopNAR5FQMiMKwV

    • While pushing the lock button to the unlock position, slide the battery out and away from the laptop.

    • When sliding the new battery back into the socket, you'll know it's secure when you hear a click.

  3. LpY5TgBdJWaZg3FZ
    LpY5TgBdJWaZg3FZ
    uORBBXuuHAQnije3
    nDKUEAAsDbe21Evl

    • Use a Phillips #0 screwdriver to remove three screws from the back panel.

    • Carefully pull the panel off of the back of the laptop to reveal the RAM sticks.

  4. YyZOroDpofgMCLwy
    YyZOroDpofgMCLwy
    VWQiUhZiYVfIQfZN
    ndnm6wudBR4UavkY

    • Two clips secure the RAM stick in place, one on each side. Using your fingers, spread the clips away from the RAM stick.

    • When released, the RAM stick will pop up at a slight angle.

    • Lift the RAM stick to an angle of about 30 degrees and slide it out.

    • When handling the RAM stick, only touch the outside edges. Take care not to touch the gold-colored contact points along the bottom edge.

    • To install a new RAM stick, slide it in place at about the same angle until it's snug, and then swing it downward until the two clips snap into place.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Cameron Popillo

Membro da: 20/03/23

337 Reputazione

0 commenti