HP LaserJet P1102w Power Plug Replacement

Scritto Da: Myles Nofsinger

Commenti: 3

HP LaserJet P1102w Power Plug Replacement

Difficoltà

Moderate

Passi

Tempo Necessario

15 - 20 minuti

Introduzione

These steps will show how to replace the power plug from the printer. This guide may be used if the prongs of the plug are broken or if a new power supply is needed all together.

Strumenti

Passo 1

Flip printer on it's back. Using the plastic spudger, pry off front panel. There will be two main points to focus as shown.
Pry carefully to not break any plastic.

my two main points were precisely under the rubber feet, they were surprisingly difficulty to dislodge.

Peter Taffs -

Passo 2

Now that the pry points are free lift up the front panel.

Passo 3

Unscrew the #1 Phillips screw 6mm on the back of the printer.

Passo 4

Using the plastic spudger, remove the button housing from the top left of printer.
Pry carefully to not break any plastic.

Passo 5

Once the housing is removed, remove the three buttons.

Passo 6

Use the plastic spudger to remove the side panel. There are three main prying points as shown.
Pry carefully to not break any plastic.

mine had a PH2 screw on the printer back thru the side panel into the aluminum serial plate/back, placed in the 2nd and third picture in the tab with a round screw hole and square locator hole. Critical clips were center back, center top and center bottom, and two points on the front.

Peter Taffs -

edit, i see the screws talked about in step 3. sorry.

Peter Taffs - 04/01/24