HP Pavilion 15-cc561st Display Replacement

Scritto Da: Bhargav Patel

Commenti: 0

HP Pavilion 15-cc561st Display Replacement

Difficoltà

Moderate

Passi

Tempo Necessario

Nessuna stima

Introduzione

This guide shows you how to replace the built-in LCD display screen of the HP Pavilion 15-cc561st. This can fix issues such as broken screen, discolored screen, flickering screen, burnt-out pixels, etc.

Strumenti

Passo 1

Before you begin to remove the bottom cover, shut down the computer. Disconnect all external devices and unplug the AC adapter. Flip the laptop upside down.
Use a Phillips #0 screwdriver to remove five screws from the bottom cover:
Two 5.6 mm screws
Each of these screws are beneath the two rubber feet on the rear side of the laptop (near the display hinges). You do not have to completely remove the rubber feet to remove the screws; simply peel the top of the feet to reveal the screws.
Three 5.8 mm screws
Throughout this repair, keep track of each screw size and location to avoid damaging your device.

Passo 2

Insert an opening tool into the space between the display hinges and the bottom cover.
Firmly push the opening tool upwards to separate the bottom cover from these areas.

Passo 3

Insert your opening tool and firmly push the tool upwards along the rear edge.

Passo 4

Use the opening tool again on the left and right sides.
Start prying at the areas closer to the rear of the laptop (near the display hinges) before moving towards areas that are closer to the front of the laptop (away from the display hinges).
Pry a little bit on the left side, then pry a little bit on the right side before prying more on the left side again. Working on both sides in this incremental fashion is easier than completely prying one side before starting the other side.

Passo 5

Lift the bottom cover upwards to remove it.

Passo 6

Use a Phillips #0 screwdriver to remove the five 5.7 mm screws that secure the battery.

Passo 7

Pull the battery towards the front edge of the laptop to disconnect it from the 8-pin battery connector.
Lift the disconnected battery upwards to remove it.
Calibrate a newly-installed battery to help your laptop get an accurate battery percentage reading.

Passo 8

Disconnect the WLAN antenna cables from the terminals on the WLAN module:
Cable labeled "1/AUX" which connects to the "Aux" terminal
Cable labeled "2/MAIN" which connects to the "Main" terminal

Passo 9

Use a Phillips #0 screwdriver to remove the 3.0 mm screw that secures the WLAN module.
Removing this screw will cause the WLAN module to tilt up.

Passo 10

Pull the WLAN module away from the slot at the angle it rises from.
Line up the notches on a new memory module with the slot. These notches are designed to prevent incorrect insertion.

Passo 11

To remove the ZIF ribbon, lift the plastic tab and gently pull the ZIF ribbon away from the connector.

Passo 12

Remove a total of five 6.65 mm Phillips-head screws with Philips #00 screw driver.

Passo 13

To separate the display assembly from the keyboard assembly, rotate the display hinges away from the motherboard.
You may need to pry apart the hinges with the display assembly by turning the computer around and pulling keyboard assembly towards yourself while holding the display assembly to the table.

Passo 14

Use the black plastic spudger to pry the screen frame from the LCD display
Repeat all around the frame until you can pull the screen frame off of the display asembly.