Huawei P40 Lite Screen Replacement

Scritto Da: Alexander

Difficoltà

Moderate

Passi

Tempo Necessario

30 minuti

Introduzione

Apply a little heat around the base then, using a suction cup, lift the screen up sufficiently that you can place a pick between the screen and the case.
The adhesive is very light and the rear is plastic so it is unlikely to break.
As well as the adhesive around the outside of the screen, there is adhesive around the camera which will also need to be heated and separated from the body of the screen.

Remove the 10 Phillips #00 screws, including the one covered in a white piece of paper.

Is there any difference between two colors of the screws? There are black and silver ones.

Use a spudger to lift up the battery connector (being careful not to damage the surrounding circuitry).

Peel the black plastic from the battery. The adhesive here should be very light.

Should I peel the whole black thing of just lift up the part covering the battery?

I REALLY HATE HUAWEIs PULL TABS! (Just wanted to get that out my system)
Peel back tab 1 and 2 until they are no longer in contact with the battery
Peel back tab 3 and lift up.
This in theory lifts the battery, however, the adhesive holding the battery in is very strong.
You must be patient and careful so as not to deform the battery.
You may need to use a pick under tab 3 to leverage the battery out.

Use a spudger to disconnect the screen connector from the motherboard and lift the cable from the adhesive.

Apply heat to the edge of the screen, and use a suction cup or blunt scalpel to help work a plastic pick under the screen.
PLEASE NOTE THERE IS A PLASTIC FRAME BETWEEN THE PHONE CHASSIS AND THE SCREEN.
Make sure your pick is between the screen and the frame and not the frame and the chassis.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Membro da: 17/03/13

216 Reputazione

Merci beaucoup pour ce partage de connaissance, c'est top !