Infant Optics DXR-8 Power Button Replacement

Scritto Da: Thomas
  • Commenti: 5
Infant Optics DXR-8 Power Button Replacement

Difficoltà

Easy

Passi

6

Tempo Necessario

15 minuti

Introduzione

  1. GOcvjwfgMcdXpsse
    GOcvjwfgMcdXpsse
    ZsNhD23SUDoHGrU5
    jT1ghDUBpspqWsjW

    • Using the plastic opening tool, remove screen protector from front of monitor.

    There's a layer of adhesive between the screen protector and the white plastic behind it.

    Jared Astillero -

    The cover is glued on. So you’ll nee d quite a bit of force to bend it up. But then it’ll come lose glue point by glue point. At first I was afraid that I’ll break it.

    Marco Smolla -

  2. N5QZknKvCQOlQXcL
    N5QZknKvCQOlQXcL
    GhBMVduKGErGhmVM
    lI14wgJlKmQ6WYFx

    • Remove the six 4mm screws using a Phillips #00 screwdriver.

    • Remove the screen, exposing the circuit board.

    • Turn device over to expose rear circuit board.

  3. eZKvBkxC6t3jITrS
    eZKvBkxC6t3jITrS
    PhVBd2P6MqTojxIG
    dGHmHmoHMHY1YTkv

    • Disconnect speaker from monitor for ease of access by unplugging wire.

    Thank you so much for this - and thank you to the commenter who walked through the additional screen replacement steps! I’ve never done anything like this and I managed to replace the screen myself.

    Lauren Skinner -

  4. fwSIywTtLs4rDsDG

    • The power button is located at the top of the device.

  5. xrZy1RPqOofG2Nqg

    • Remove the button by picking it up out of the hole it is connected to.

  6. EveFS5feMe4AyTsr

    • Insert a new button by placing the small end in the hole to connect the button to the device.

Conclusione

To reassemble your device, follow the instructions in reverse order.

Autore

Thomas

Membro da: 02/10/19

133 Reputazione

2 commenti

Where did you get the replacement switch?

Dave Peterson -

Where can you purchase a new power switch on the circuit board for replacement?

Derrick Silvestri -