Introduzione

Use this guide to replace the freezer ice maker on your LG LFX25973 refrigerator.

The freezer ice maker provides a supply of ice stored in your freezer drawer.

When the freezer ice maker malfunctions, you will not have ice available in the ice bucket in the freezer drawer.

  1. SaOfLbkeAxgmho5g
    • Unplug your refrigerator before you begin your repair.

    • If you are testing or repairing the following items, you may also need to shut off and disconnect the water supply:

    • Condenser Fan Motor

    • Compressor Motor and Thermal Overload Device

    • Water Supply Valve Assembly

  2. OKxbMtWRmoXOWyaR
    OKxbMtWRmoXOWyaR
    GcR3eNwYXLI2Qllc
    • Pull open the freezer door fully.

  3. 2lstsmEMiHTWgUI2
    2lstsmEMiHTWgUI2
    gkhWaS2A6wVNAVhg
    miQiZbjUkYAZ1dFi
    • Lift and remove the upper pull-out drawer.

    • Lift and remove the main drawer bin.

  4. VIRitIupMYa24tnO
    VIRitIupMYa24tnO
    qrIEYbAKiKuqdVBB
    n1MaTf5Mg3rZgyoH
    • Use your finger or a flat-blade screwdriver to depress the two locking tabs on the right drawer rail cover.

    • Lift the cover off of the rail and remove it.

    • Repeat this procedure for the left drawer rail cover.

  5. MEFyDdexR14BxaWf
    MEFyDdexR14BxaWf
    uLs4YXSkTmIIIFjp
    • The drawer rail covers can be tricky to reinstall. Follow these steps to reinstall them:

    • Hold the drawer rail cover flush against the side of the drawer rail.

    • You should feel the locking tabs protruding.

    • Push the rail cover straight downward to install. It should click into place.

  6. SpYpPYmrhf5JehPm
    SpYpPYmrhf5JehPm
    DWMnfT2SOUXOEaKB
    • Use a Phillips screwdriver to remove the 10.4 mm‑long screw securing the drawer to each of the drawer slides.

  7. 52fl1tpPKkW2fGCO
    52fl1tpPKkW2fGCO
    TOksEKHvrCDBMprw
    EnwpcK2kqHt15Tgf
    • Lift the front of the drawer up.

    • Pull the drawer toward you to release the drawer from the drawer slides.

    • Remove the freezer drawer.

  8. 65jVx2OUgBhX4NBP
    • Use a Phillips screwdriver to remove the two 22.5 mm‑long screws securing the ice maker to the top of the freezer compartment.

  9. HN6phJTbgGOAoJTL
    HN6phJTbgGOAoJTL
    6TneoZ2BSIDcyVEt
    EuQyLxCpp2MMEDOE
    • Insert a flat-blade screwdriver into the slot located on the right edge of the ice maker.

    • Pry outward with the screwdriver to release the locking tab securing the ice maker to the fridge.

    • When the tab releases, pull the right front corner of the ice maker down.

  10. gpLr1jom3UfnQH4O
    • Repeat the previous operation on the left side of the ice maker to release it.

  11. wR1MSK4oIdqHfyqi
    wR1MSK4oIdqHfyqi
    FHUtX2326WhLU3ep
    k6MjLiNlXvDdNlSM
    • Grasp the front edge of the ice maker and pull it towards you.

    • Lower the ice maker.

  12. qGuLXVxPvXFVbGbq
    qGuLXVxPvXFVbGbq
    GV1CR64HOCHepxCr
    OBPBQYxdewuW5vZJ
    • Squeeze the ice maker connector to release it and pull it straight out to disconnect it.

    • Remove the ice maker.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our  Answers community for help.

Bill Gilbert

Membro da: 30/06/22

29837 Reputazione

0 commenti