Introduzione

If your audio quality is much worse than it used to be, you may need to replace your speaker system! The most common cause of poor speaker performance is because of water damage over time.

If your charger port is no longer working, it could be because of dirt clogged within the speaker. Try to clean the port and see if it works before replacing the entire port.

Before using this guide, make sure to review the LG V50 ThinQ troubleshooting page to ensure there are no other options to save your speakers or charging port.

If the speaker system or charger port needs to be replaced, this guide will help you replace them for your LG V50 ThinQ android phone. Make sure the device is powered off before replacing any parts.

  1. XCUssFyBYED5NZdH
    XCUssFyBYED5NZdH
    qjbuEmOrY1CReIBA
    faJJQ3rLLnhKTkbG
    • Flip the phone over, so that the back of the phone is facing you.

    • Using an opening pick, pry open the back cover of the phone by moving the opening pick along all sides to reveal the internal components.

  2. XSiDWTmrMZZAsf1g
    XSiDWTmrMZZAsf1g
    gw4uOvABEKK4Paic
    13VlMcV4qSI1boYS
    • With the back side open, remove all 12 1 mm Phillips #000 screws.

    • Remember to keep the screws in a safe place for reassembly later!

  3. eltoaNMSFGC4yJnW
    eltoaNMSFGC4yJnW
    QyV5kCACMSsvZgJZ
    2iSXbK5q63M1apYC
    • Remove the two brackets that are covering internal components.

  4. P5gUqBFeMygNFPUu
    P5gUqBFeMygNFPUu
    qIAEtIVnkdEC2k3a
    JcwIGALWXgRy44pJ
    • Disconnect the battery from the phone by removing the battery connection from the connector port.

    • Disconnect the orange cable by pulling the connector up with your fingers.

    • Pull up with tweezers on the end of the white wire to disconnect it from the two circuit boards.

    • Pull up with tweezers on the dark orange cable to disconnect it.

  5. IVdR1sYDkIAErUT5
    IVdR1sYDkIAErUT5
    ZbMRcNQegfunjXoE
    rgpGfgAyf4mvXHJi
    • Take out the SIM card by using the SIM head and pushing into the SIM ejector slot.

    • Disconnect the orange panel nearby the SIM slot from the circuit board.

    • Pull up from below the circuit board on the top, next to the CMOS battery to remove the upper circuiting from the phone.

  6. MGctyDfFDEb4IZnw
    MGctyDfFDEb4IZnw
    UQfRH6MufQxsvRbY
    PjfiNi3SVKeAxXL2
    • Pull up from the right of the metallic cover piece inside of the bottom right of the phone.

    • Remove the metallic piece's base from the board.

    • Make the cubic piece moveable by wiggling under it with an opening pick or spudger.

  7. LokWIgAPegLTcKY3
    • Remove bottom circuiting, the speaker system is a part of the bottom circuit board.

Conclusione

To reassemble your device, follow these instructions in reverse order.

William Martin

Membro da: 01/11/23

231 Reputazione

0 commenti