Introduzione
Strumenti
-
-
Use a Phillips #1 screwdriver to remove the five 5.0 mm screws from the base panel.
-
Wedge a spudger between the base panel and chassis, and pry around the entire perimeter until you hear a pop and the base panel releases.
-
Lift the base panel up and off of the chassis.
-
Conclusione
To reassemble your device, follow these instructions in reverse order.
For my X1 carbon G9, three of the screws holding the plate on didn't actually come out. I loosened them, removed two of the screws, and then was able to leverage the spudger to pop out the plate.
Luke McDermott -