Logitech Extreme 3D Pro Joystick Trigger Replacement

Scritto Da: Emanuel Canela
  • Commenti: 0
Logitech Extreme 3D Pro Joystick Trigger Replacement

Difficoltà

Easy

Passi

4

Tempo Necessario

1 - 5 minuti

Introduzione

After a long use the joystick trigger might experience a lack of strength within the trigger's internal spring.

  1. ifhZCZwXn2SySdkS

    • Remove these three Phillips #1 screws:

    • Two 10mm screws.

    • One 7mm screw.

  2. 66wFFnSOg3jfoFnD

    • Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.

    • Remove the two 10mm Phillips #1 screws.

  3. Lqxji5uwBiv2KAyJ
    Lqxji5uwBiv2KAyJ
    HRc6nwCxcxt1XuFb

    • Pull apart the joystick chassis by hand.

    • Release this clip located underneath the hand rest

    • The circuit board will be loose and may fall down.

  4. LA4iKOyHcW4Wx1CU

    • Remove the plastic trigger from the joystick.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Emanuel Canela

Membro da: 25/01/18

1297 Reputazione

0 commenti