Introduzione

This guide is for replacing the LiPo Rechargeable Battery Logitech G Pro X Lightspeed. You battery may need to be replaced if your headset only turns on when plugged in or doesn't hold a long charge (factory spec is ~20 hours).

For your safety, discharge the battery below 25% before disassembling your device. Inspect batteries for physical and chemical damage. Battery should not be swollen to any extent. For non-OEM batteries, make sure your wires match with the original.

  1. 3xI1HIPeopxLnsqp
    3xI1HIPeopxLnsqp
    FwvcY5jHKbwdjCZB
    • Prepare headset. Remove mic and set power switch to off

    • Replacement part #533-000084. 1100mAh 3.7V 603450 Li-polymer battery

  2. 5XILFi44leWVnS1L
    • Remove right earpad labelled "R"

  3. SnVHGL4GN1UQ3uF1
    • Using a Philips 00 driver, remove 4 screws.

  4. vm3B52r2aErMSOHc
    • Open headset and carefully remove adhesive holding battery

  5. WjeY4eLtJPIdUIIi
    • Remove single screw holding PCB in place using a Philips 000 driver.

  6. STXqrwHGYULYv4rR
    • Disconnect JST connector carefully using tweezers. Do NOT pull on the wires directly.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Milan Joaquin

Membro da: 07/01/24

269 Reputazione

0 commenti