MSI GE72 6QF Apache Pro SSD Replacement

Scritto Da: Tanmay Kumar

Commenti: 6

Difficoltà

Easy

Passi

Tempo Necessario

10 minuti

Introduzione

This guide will teach you how to replace the SSD on your MSI GE72 6QF Apache Pro

Strumenti

Phillips #1 Screwdriver

Ricambi

Passo 1

Make sure the laptop is off and unplugged (not charging).
With the laptop closed and upside down, unscrew the nineteen 5.5mm Phillips #1 screws that keep the back cover in place.

Passo 2

Slide the optical drive out of the laptop.

Good day sir pls am urgently look for the complete cd rom for this laptop msi 1791. Please if u can get some for me text me on 7186034112

rauffsulemane -

Or send me and email rauff191@gmail.com

rauffsulemane -

Passo 3

Use a Phillips screwdriver to remove the three screws along the edge of the optical drive bay.

Passo 4

Using your fingers, gently loosen the edges of all four sides of the back cover.
Gently pull off the back cover.

Passo 5

Unscrew the single 5.5mm Phillips #1 screw keeping the battery secure.

Passo 6

Grab the battery with your fingers and gently pull it up and away from the rest of the laptop.

Passo 7

Remove the single 5.5mm Phillips #1 screw attaching the SSD to the laptop.

what do i need to go to a bigger 256 ssd . will i need to program windows again? 3 yr. old msi ge72 6qf apache pro 17” thanks, Brian

sixspdvett - 10/01/21

Passo 8

Pull out the SSD by gently wiggling it from side to side until it comes out.
If the old SSD you removed contains the operating system, then the new SSD must also contain an operating system.

Thanks folks, I was most the way through the disassembly process and had to stop as the base cover would not fully release. There was a spot at the back left corner (if your were looking at the laptop keyboard from normal typing position (right back corner if you were working to remove the back cover from the bottom)). It seemed to be stuck, is there an insulating pad that might also be an adhesive when heated? I was forced to give up as I found no clips, latches or screws holding it in place.

What was preventing the back corner of the cover from releasing please?

Pete - 29/03/20

Hello @welltech20 , I have the MSI GE72 VR, this model has the same chassis. When I opened the laptop, I noticed there are lot of clips retaining the bottom case. Also, there is the USB type C port is inserted in the bottom case. It's a little bit difficulte to open this laptop because the clips are very well attached and the side of the bottom case with the USB type-c port must be lift after the 3 other sides, because you need to slide the side of thé bottom case with the USB type C port to free the bottom case from this port, as this USB type C port is soldered to the motherbord and is inserted in the bottom case. Also be carfull when you will reasemble the laptop bottom case because of that. A plastic opening tool is very usefull to detach all the clips.

Moreover, there is an hidden screw behind a waranty sticker on the bottom case perhaps there is one on your laptop too. There is lot us screws maintaining thé bottom case (14 on my laptop), ensure there is no remaining screws.

Have a nice day

Brendan - 10/01/21

There are clips on the back corner too, they are a little bit difficult to detach the first time.

Brendan - 10/01/21