MacBook Air 11" Late 2010 I/O Board Cable Replacement

Scritto Da: Andrew Bookholt

Difficoltà

Moderate

Passi

Tempo Necessario

Nessuna stima

Introduzione

Use this guide to replace a damaged I/O board ribbon cable.

Before proceeding, close your computer and lay it on a soft surface top-side down.
Remove the following ten screws:
Two 8 mm 5-point Pentalobe screws
Eight 2.5 mm 5-point Pentalobe screws
The special screwdriver needed to remove the eight 5-point Pentalobe screws can be found here.

I recommend that one of the tools you obtain is a jeweler's loupe that mounts on your glasses. It makes things easier.

This is not correct. You need the pentalobe tool at this point.

Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
Remove the lower case and set it aside.

In this step you will disconnect the battery to help avoid shorting out any components during service.
Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.
Bend the battery cable slightly away from the logic board so the connector will not accidentally contact its socket.

Use the flat end of a spudger to pry the I/O board cable connector upward out of its socket on the I/O board.

The following connector has an especially deep socket. Use care when disconnecting it.
While gently pulling the I/O board cable upward near its connection to the logic board, use the tip of a spudger to pry upward on alternating sides of the connector to help "walk" it out of its socket.
Remove the I/O board cable.

Conclusione

To reassemble your device, follow these instructions in reverse order.

585555 Reputazione