Introduzione
The sync component connects your Mad Catz Rock Band 4 Wireless Fender to the Xbox. This hardware is responsible for your wireless rock experience. If you have not seen the troubleshooting page which shows how to re-sync the controller without a part replacement, click here.
Be sure to remove the batteries before doing any of the following steps.
Strumenti
- 
                  
                  
- 
            
Flip the guitar over so it is back side up. The battery compartment should be facing up.
 - 
            
Use a size J1 head screwdriver to remove the ten 5 mm short screws.
 - 
            
Use a J1 screwdriver to remove the four 5 mm long screws on the back of the device.
 
 - 
            
 - 
                  
                  
- 
            
Turn the device over so the front of the guitar is facing you.
 - 
            
Using a size J1 philips head screwdriver, remove the eleven 5 mm silver screws (circled in red) around the white panel.
 
 - 
            
 - 
                  
                  
- 
            
Gently lift the white panel and twist 90 degrees clockwise.
 - 
            
Using a size J1 head screwdriver, remove the two 5 mm black screws from underneath the white panel. You should now be able to pull the guitar apart.
 
 - 
            
 - 
                  
                  
- 
            
Remove the two black 5 mm screws (circled in red) from the back of the power button component using a size J1 philips head screwdriver. You can identify this by the code J5-B on the component.
 - 
            
Lift the small, rectangular circuit board out and set it aside.
 
 - 
            
 - 
                  
                  
- 
            
Locate the sync component hardware. It is a small circuit board that sits sideways with respect to the other circuit boards around it.
 - 
            
Remove the two 5mm black screws (circled in red) holding the circuit board in place using a size J1 philips head screwdriver. The component should now slide out vertically.
 
 - 
            
 - 
                  
                  
- 
            
Follow the wires connected to the sync component back to the main circuit board. Unplug the component from the main circuit board.
 
 - 
            
 
To reassemble your device, follow these instructions in reverse order.
Un commento
How do I replace the sync wire? Where can I purchase a new sync component?
Ange -