Mad Catz Street Fighter IV FightPad Front Case Replacement

Scritto Da: Eric
  • Commenti: 0
Mad Catz Street Fighter IV FightPad Front Case Replacement

Difficoltà

Moderate

Passi

10

Tempo Necessario

15 minuti

Introduzione

Removing the FightPad's front case for replacing the case or front artwork.

  1. pm416YSWvG5ucNwk

    • Use tweezers to completely remove the sticker from the rear of controller.

  2. 3uXvLlgQHkmtRRUM

    • Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

  3. FumE6DnlEejBvJim
    FumE6DnlEejBvJim
    EOnKxbsxMUVWcPcp

    • Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.

    • Use the plastic opening tool to pry the two cases apart.

  4. VVEjO1MLOoycT6Qt
    VVEjO1MLOoycT6Qt
    IJqQCC1YUNNyCDK3

    • Remove the two rubber side grips.

  5. 6mf2FoIsZRtoAyTA
    6mf2FoIsZRtoAyTA
    unvODXCdUGvmTYGU

    • Locate RS-DP-LS switch.

    • Pull upwards on the switch to remove it.

  6. viIJjwUHe2BtVuuD

    • Locate the four 8.3 mm Phillips screws on the circuit board and remove them.

  7. hiophYM5WgcCxTmQ
    hiophYM5WgcCxTmQ
    s33OpVCF5QyrPnlp
    fJSaAKgMbFlQCEAW

    • Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.

    • Be careful with the wires connected to the circuit board itself as they are thin and delicate.

    • When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.

  8. COJhI2BZBUIlteNR
    COJhI2BZBUIlteNR
    Dd1GrdRVNEcctWv5

    • Remove the six buttons one by one by gripping the back of each one and pushing on them from the front.

    • Use tweezers to remove the rubber part of the directional pad before you try to remove the shoulder buttons.

    • When reinserting the buttons make sure they are in the correct place and oriented correctly.

  9. LsHO2XAg6InClMyo

    • Remove the left and right shoulder buttons by sliding them out of their respective slots.

  10. hGxokpH4XLlccxHp
    hGxokpH4XLlccxHp
    BcTqEvBPn4aukjWW

    • Pull the plastic piece out from the bottom of the controller.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Eric

Membro da: 26/09/12

117 Reputazione

0 commenti