MartinLogan Motion 4i Back Cover Replacement

Scritto Da: Austin Paul
  • Commenti: 0
MartinLogan Motion 4i Back Cover Replacement

Difficoltà

Moderate

Passi

6

Tempo Necessario

15 - 25 minuti

Introduzione

Use this guide to disassemble the speaker to replace the components inside your MartinLogan Motion 4i model number.

In order to complete most of the other replacement guides you have to take off the back cover.

  1. yNeecFMCKlcqWpXl
    yNeecFMCKlcqWpXl
    ONCGUbYGgSqATbHL

    • Remove the speaker grill from the face of the speaker by using both hands to grip both ends of the speaker grill and pulling up to release the magnetic ends.

  2. gwrTO2qgPormeVCi
    gwrTO2qgPormeVCi
    uQSttmabmybGl3hJ
    OoeCHuacgVQnEeNW

    • Remove the six caps from the outer edge of the face of the speaker with an iFixit opening tool.

    • Make sure to remove the rubber caps slowly and carefully so that the ends won't break off and create a blockage above the screws.

  3. QhUNV6fOuENZhUNG

    • Remove the six 4 mm Phillips #2 screws that are located inside each of the holes where the rubber caps used to be.

    • The screws vary in depth, therefore you will need a Phillips #2 screwdriver that is around 6 inches in length from the tip to the start of the handle.

  4. FUfrjXSSIdbWNoqk

    • Place the device face-down, then lift off the back case with both hands.

    • The speaker sometimes takes a little effort to remove the speaker back, so we recommend that you give it a couple shakes by placing each hand on the speaker face and the back when shaking.

    • If you decide to use the shaking method, make sure you're near an immediate surface near you just in case it drops.

  5. ZFiXSlRfwMPIRNgO

    • Lightly grip the material that insulates and covers the speaker components and remove it by pulling up.

  6. wTT1HdPSFjMxExQn
    wTT1HdPSFjMxExQn
    YoYGRoVqTLvnYuLt

    • Remove both wires that are connecting the back of the speaker to the components of the speaker to fully access the speaker components.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Austin Paul

Membro da: 13/09/23

379 Reputazione

0 commenti