Introduzione
Follow this guide to remove the motor and pump assembly from a Mi-T-M heater model MH-0190-0M10.
This is a prerequisite-only guide! This guide is part of another procedure and is not meant to be used alone.
-
-
Flip the power switch into the OFF position.
-
Unplug any extension cords from the included power cord.
-
-
-
Use a 5/16 inch socket or Phillips screwdriver to remove the eight screws securing the upper shell, four on each side.
-
-
-
Use a 5/16 inch socket or Phillips screwdriver to remove the four bolts securing the right-side cover.
-
-
-
Use needle nose pliers to remove the wire with the blue connector.
-
Remove the wire with the clear connector.
-
Remove the right-side cover.
-
-
-
Use a 5/16 inch socket or Phillips screwdriver to remove the screw securing the two green ground wires to the frame.
-
-
-
Use a pair of needle nose pliers to release the hose clamp from the fuel line.
-
Slide the hose clamp off of the nipple, about one inch down the fuel line.
-
-
-
Use a pair of needle nose pliers to disconnect the wires connecting the motor and pump assembly to the main PCB board:
-
One red cable labeled MOTOR 2 on the main PCB board
-
One orange cable labeled MOTOR 1 on the main PCB board
-
-
-
Use a pair of flush cutters to cut the cable tie harnessing the wires running from the main PCB assembly.
-
Remove the cable tie.
-
-
-
Use a pair of flush cutters to cut the cable tie harnessing the orange, red, white, and black wires near the fuel line.
-
-
-
Use a pair of flush cutters to cut the cable tie harnessing the orange and red wires next to the motor.
-
-
-
Use a 5/16 inch socket or Phillips screwdriver to remove the four bolts securing the left-side cover.
-
-
-
Use a 5/16 inch socket or Phillips screwdriver to remove the four screws securing the motor mount bracket, two on each side.
-
To reassemble your device, follow these instructions in reverse order.
