Motorola Moto 360 3rd Gen Battery Replacement

Scritto Da: Samuel Jason Trammell
  • Commenti: 2
Motorola Moto 360 3rd Gen Battery Replacement

Difficoltà

Moderate

Passi

6

Tempo Necessario

15 - 25 minuti

Introduzione

If your Motorola Moto 360 3rd Gen smartwatch is having trouble holding a charge, or is not charging at all, you might need to replace the battery. Before replacing the battery, make sure that there is no dust around the charging pins or ports. Furthermore, make sure that you power off your phone completely and disconnect from any external power source.

  1. Hx2UCBj1dHKnYEgu
    Hx2UCBj1dHKnYEgu
    OPkf3pyXL6EqWPhK

    • Use a T4 Torx screwdriver to remove the four 4.2 mm screws securing the lower case.

    • Gently pry the case open with a halberd spudger if the case will not release after removing the bolts.

    • Do not remove the lower case completely yet; this could damage cables connected to the lower case.

  2. mqacXNVYXjbUrr65

    • Raise the cover without straining the connected ribbon cable.

    • Disconnect the ribbon cable from the motherboard with a halberd spudger.

  3. r1anVxXeQDfxcCYp
    r1anVxXeQDfxcCYp
    nNuhSGWPTokHMrtG
    DF2k1hPMVpxvVnM3

    • Use a halberd spudger to lift the three flat-top connectors straight up to disconnect them.

    • Do not disconnect the battery (bottom-left) cable yet.

  4. kK6SEwuCN2KujGLA
    kK6SEwuCN2KujGLA
    ZGf5xf5KvbHIsMQ2
    GtT4XFpaIK14H5Gf

    • Gently remove the motherboard using the halberd spudger.

    • The best area to pry is at the bottom of the motherboard, right under one of the ribbons that was just disconnected.

  5. wYQTAObAir5sk1GS
    wYQTAObAir5sk1GS
    bNR6LKknawdIlbcr
    BHkigZ3q6WRQL4Xi

    • Flip the motherboard over so the battery is facing upwards.

    • Gently pry the battery out of the motherboard housing.

    • The best area to pry is at the top-left corner.

    • Take care not to puncture, bend, or twist the battery while removing it. A damaged battery can start a fire!

    • Disconnect the battery ribbon from the motherboard using the spudger tool.

  6. PRb4ponOAxORbMbm
    PRb4ponOAxORbMbm
    cG1wASESsBKoiSSo

    • Connect the new battery's ribbon to the motherboard.

    • Insert the new battery in the same orientation the old battery previously had.

Conclusione

To reassemble your device, follow these instructions in reverse order carefully.

Autore

Samuel Jason Trammell

Membro da: 09/02/23

186 Reputazione

2 commenti

Excellent guide, thanks. Any luck in finding a replacement battery?

Emiliano Brunetti -

Same. No idea where to get a replacement battery

Chandler Prude -