Introduzione

In this guide you will be able to replace the filter of the Neato Botvac Connected. The filter will need to be changed or cleaned once too much debris has built up causing the vacuum to no longer pick up dirt. The filter of the vacuum should be changed every few months to ensure the Neato Botvac is picking up debris properly. Following this guide comes after first following the guide to replace the battery to ensure safety.

  1. JxTf5FESEpAYLZZL
    • Place the top of the Neato Botvac Connected against a flat surface.

  2. I1VBxxGJVUaWONWZ
    I1VBxxGJVUaWONWZ
    ecocLqHSQLKRy1Qt
    • Remove the two 5.5 mm screws with a Phillips #2 screwdriver.

  3. hvXQuugkQkLrLvBv
    hvXQuugkQkLrLvBv
    mwyiZ6JYEH6MR5ZS
    • Using the spudger, remove the panel covering the battery.

  4. DxUSMhlG4PT2VlnN
    DxUSMhlG4PT2VlnN
    c1I5pYQ1nDPvjkVH
    uvwbWob3CQeQFRCy
    • Gently remove the connecting wires attached to the battery.

    • The wires are attached to the vacuum through a clip.

  5. b1raCqKE1IhWccDx
    • Using the spudger, gently remove the battery from the device.

  6. twBj2yDXNBsFi2gO
    • Flip the cleaner around and locate the front panel.

  7. 52BFFsAOZcBfZ4JC
    • Gently remove the front panel by opening it with a spudger.

  8. HWorexUE5DXLJREP
    HWorexUE5DXLJREP
    qkSVBJlARlSSwRiq
    • Use the spudger to gently remove the paper filter.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Justin Silva

Membro da: 20/03/23

645 Reputazione

0 commenti