Neato BOTVAC CONNECTED Side Brush Replacement

Scritto Da: Justin Silva
  • Commenti: 0
Neato BOTVAC CONNECTED Side Brush Replacement

Difficoltà

Moderate

Passi

13

Tempo Necessario

15 - 20 minuti

Introduzione

In this guide you will be able to replace the side brush of the Neato Botvac Connected. Replacing the side brush would be necessary if its not spinning properly. This could also be replaced if there are excess debris stuck in the brush. As a precaution make sure to disconnect the battery before beginning this guide.

  1. JxTf5FESEpAYLZZL

    • Place the top of the Neato Botvac Connected against a flat surface.

  2. I1VBxxGJVUaWONWZ
    I1VBxxGJVUaWONWZ
    ecocLqHSQLKRy1Qt

    • Remove the two 5.5 mm screws with a Phillips #2 screwdriver.

  3. hvXQuugkQkLrLvBv
    hvXQuugkQkLrLvBv
    mwyiZ6JYEH6MR5ZS

    • Using the spudger, remove the panel covering the battery.

  4. DxUSMhlG4PT2VlnN
    DxUSMhlG4PT2VlnN
    c1I5pYQ1nDPvjkVH
    uvwbWob3CQeQFRCy

    • Gently remove the connecting wires attached to the battery.

    • The wires are attached to the vacuum through a clip.

  5. b1raCqKE1IhWccDx

    • Using the spudger, gently remove the battery from the device.

  6. jpqa1uTIYaVCIDuy
    jpqa1uTIYaVCIDuy
    suaB6khXjvpi2iiR

    • Remove the following screws with a Torx screwdriver:

    • Four 2.3 mm screws.

  7. NXWuDcnfEwORn6qh

    • Gently remove the thin panel held by the four screws with a spudger.

  8. GjtiWXFiSvaIHEiJ

    • Gently remove the two small wheels, and the axles attached to them.

  9. vBSPXKtwjVHGdTbP

    • Gently remove the panel that is on top of the front roller with the spudger.

  10. EJEIIUEU46yJZQJQ

    • Gently remove the front brush.

  11. 4aIMjDRiF61NndI3
    4aIMjDRiF61NndI3
    WjGEPeIXJdSXQjqd

    • Gently twist the side brush back and forth.

  12. SyfkTq21cRLoSUlC
    SyfkTq21cRLoSUlC
    ZHIQITjfDcSAEulK
    vXTHtKsQoRftJWqk

    • Spin the side brush counter counterclockwise.

  13. XRgXN1Ormp1Bslj3

    • Use the spudger to gently pry up and remove the side brush.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Justin Silva

Membro da: 20/03/23

645 Reputazione

0 commenti