Nest Thermostat E Motherboard Replacement

Scritto Da: Andrew Ahlborn
  • Commenti: 0
Nest Thermostat E Motherboard Replacement

Difficoltà

Moderate

Passi

5

Tempo Necessario

5 minuti

Introduzione

Replacing the thermostat motherboard on your Nest couldn't be easier. The only tools required are tweezers, a Phillips #0 screwdriver, and the opening tool.

  1. VoBiLwSNxKWSFNNp

    • Grasp the display's outer ring with your fingers and pull directly away while rotating clockwise to remove the thermostat from the wall.

    • Go to the electrical panel and turn off the circuit to make sure no power is running to the thermostat.

    • Once the power is off, disconnect the Y1, G, R, W1, C, and OB wires.

    • Remember the placement of each wire for reassembly.

  2. EopR1DJBuaSoJZhH

    • Remove the two 1 ¼” drywall screws holding the base display and base plate in the wall using a Phillips #2 screwdriver.

    • Remove the base plate and base display.

  3. AJTXCDgMdeSSq3xX

    • Pry the base display off of the baseplate using an iFixit opening tool.

  4. iosjIsRMJILUJRgc

    • Remove the four 6 mm screws using a Phillips #0 screwdriver.

    • The two smaller screws go around the pin connector and the two larger screws go by the outside bezel.

    • Grab the pin connector and pull up to remove the thermostat backplate from the thermostat.

  5. qHVKnMRIqa5UdDhf
    qHVKnMRIqa5UdDhf
    dboDr2Khnh3jaJKV

    • Flip the base display over and the display motherboard will remove itself from the display.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Andrew Ahlborn

Membro da: 27/02/23

368 Reputazione

0 commenti