Introduzione
If your normally piping hot cup of coffee is coming out at room temperature then the water heater may be to blame. This replacement involves removing a number of small screws so it may be a good idea to have the iFixit magnet pad nearby. Follow this guide to replace your device’s water heater and restore heat to your Ninja Coffee Bar.
Strumenti
-
-
Detach the valve tubes from the valve by squeezing the pins and pulling them away from the valve.
-
-
-
Detach the valve tubes from the device by pinching the pins and sliding the valve tubes off.
-
-
-
Unscrew the four 6mm #1 Phillips head screws from the underside of the basket area.
-
Remove the single 6mm #1 Phillips-head screw from the side of the unit.
-
-
-
Slowly pry the upper cover away from the unit on top of the brew basket, and near the base of the water reservoir along the side of the upper cover.
-
-
-
Using a #1 Phillips head screwdriver with an extension, remove three 6mm screws holding the heater to the unit.
-
-
-
Squeeze clip and separate signal wiring.
-
Using wire stripper/crimping tool, uncrimp wiring connectors
-
To reassemble your device, follow these instructions in reverse order.
Un commento
Where can I buy the water heater?
My Ninja has T10 Security-head screws. Several are recessed quite deep in the bottom cover. I found a set of 60mm long security torx bits on Amazon for around $12 The extended length worked great for the deep recessed screws.
Mike Stroven -