Nintendo DSi XL Speakers Replacement

Scritto Da: Matthew Newsom
  • Commenti: 4
Nintendo DSi XL Speakers Replacement

Difficoltà

Difficult

Passi

15

Tempo Necessario

20 minuti

Introduzione

Replace your DSi XL's speakers so you can hear Mario yell "Mamma mia" as clear as ever.

  1. LIHVnXkBLxLAmFX2
    LIHVnXkBLxLAmFX2
    McyatAIFRiH6Rv4V

    • Remove the two Phillips screws securing the battery cover to the back of the handheld console.

    • Lift the battery cover off the back of the DSi XL.

    rust/white powder built up on a screw and can’t unscrew it

    Eco -

  2. hBMGuXT2UL1NcEKT

    • Lift the battery from the DSi XL.

  3. qD1kXXriJjKTXs4N
    qD1kXXriJjKTXs4N
    nfXjDfdJVldJcxfm
    EQ2VRssTU6XDDXTy

    • Use a push pin to remove the four plastic screw covers on the front bezel.

  4. HuDhEZYSyxQQ55NE

    • Remove four Phillips screws securing the front bezel to the rear bezel.

  5. HyFASKVqEJ1hMpFX
    HyFASKVqEJ1hMpFX
    dFaG3FhAB1K5S1HZ

    • Using two hands, gently slide the rear bezel upwards.

    • The rear bezel will move only about 2 mm.

  6. QhVDB3FIboFDf5Km
    QhVDB3FIboFDf5Km
    5hEWTJ3hAax3csy4

    • Insert a spudger into the gap between the front and rear bezel

    • Rotate the spudger away from the DSi XL, prying the two bezels apart.

  7. ONrY2YYU1HA1YBVm

    • In the same manner as described above, continue prying along the top edge of the front and rear bezels.

  8. ybbhmYo6kLsA3hrB

    • Separate the rear bezel from the front bezel.

    • Do not attempt to completely remove the rear bezel yet. It is still attached to the front bezel by the rear-facing camera.

  9. KcPYMSpvWrB3PfQM

    • Use the flat end of a spudger to pry the rear camera off the rear bezel.

    • Remove the rear bezel.

  10. H2s3BN6cpCZK2ycL

    • Use a spudger to lift the antenna from the front bezel to make room for lifting the speaker cables up.

  11. QZ1thAjau4D21YcT

    • Use a spudger to lift the right speaker from its housing in the front bezel.

  12. LYv2xSjRCOT11tGr

    • Use a spudger to lift the left speaker from its housing in the front bezel.

  13. bZFa4VwI4FhIh24S
    bZFa4VwI4FhIh24S
    UjTptQFNtfiNdIi2

    • De-route the left speaker cable along the top edge of the upper LCD.

  14. bfWBmof4ZOLfAdiK

    • Open the display slightly, and lift the LCD out of the front bezel.

    • Lay the LCD down next to the DSi XL.

    • Don't attempt to remove the LCD, it is still attached to the front bezel via the display data ribbon cable.

  15. kFkfjLkdeUihSNKO

    • Desolder the two solder joints to separate the speakers from the LCD.

    • Right Speaker

    • Left Speaker

    • For both speakers, the red wire (positive lead) is soldered to the left contact. The black wire (negative lead) is soldered to the right contact point.

    • For detailed instructions on how to solder this type of connection, see our guide for repairing soldered connections.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Matthew Newsom

Membro da: 06/01/10

39426 Reputazione

3 commenti

Thank you for this video but I need some more help cause I dont know if my problem are the speakers or the earphones jack how can I solve this just one clue i need thanks again

Josh -

In my case, it turned out there was nothing wrong with my speaker… one of the wires that feeds around the screen was bad.

Dave Horlick -

is there anyway of adding two more speaker?

vincent johnson -