Opening Case

Scritto Da: Brian W

Commenti: 2

Difficoltà

Easy

Passi

Tempo Necessario

3 - 5 minuti

Introduzione

This Prerequisite-Only guide shows how to open and butterfly the 8BitDo SN30 Pro+

Strumenti

Passo 1

Place the controller face down.
Remove the battery cover.
Remove rechargeable battery or AA batteries.

Passo 2

Remove L2 and R2 trigger buttons by pushing them away from the grips.

Passo 3

Use Tweezers to uncover two screws under the label in the battery compartment.
Use a T6 screwdriver to remove the four 7.3 mm screws securing the rear cover.

Passo 4

At the end of each grip, pry apart the covers.
Use fingernail or opening pick to undo the two top clips.
One clip next to L button.
One clip next to R button
Undo the final clip between the joysticks.

Passo 5

Carefully move the rear cover away and from the front cover. Place it to the left.
Do not completely separate. The two halves are still attached via a white ribbon cable.

I just used this guide to open a Pro2 controller, the only difference was the ribbon cable was between the analog sticks. Otherwise it went perfectly.

Dunch -

You have to be careful not to break the clip on the middle bottom (between the analog sticks)

Kelvie Wong -