PSP Go Bottom Plate Replacement

Scritto Da: Miroslav Djuric
  • Commenti: 0
PSP Go Bottom Plate Replacement

Difficoltà

Moderate

Passi

4

Tempo Necessario

15 minuti

Introduzione

Use this guide to remove the PSP Go's bottom plate!

  1. LhA1YVTFVpuSaY5i
    LhA1YVTFVpuSaY5i
    iqxlosSvmM4KTYNl

    • Unscrew the four Phillips screws on the back of the PSP Go.

    • Rotate the PSP so you can see the top of the device.

    • Unscrew the two Phillips screws next to the volume buttons.

  2. nMEVBYIvPaGa4lSm
    nMEVBYIvPaGa4lSm
    g3JkOmU5wiX4ln1G

    • Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.

    • Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).

    • Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

  3. ABedZDx5FKLfOJIa

    • Pull the top cover upwards gently from its housing.

  4. rAwimXtEyG2gOjBh
    rAwimXtEyG2gOjBh
    GhWZ2JCkjVofsNyD

    • Remove the two Phillips screws holding the bottom plate.

    • Gently lift the bottom plate away from the device.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Miroslav Djuric

158138 Reputazione

0 commenti