Introduzione

This guide will show you how to remove the outer case from your (9300 Series) Philips Sonicare DiamondClean toothbrush. This case protects the internal parts from water and toothbrushing products. If you notice the buttons are not working properly or if the toothbrush is not charging as well as it used to, residue buildup may be the problem. Replacing the outer case will help your toothbrush to maintain proper contact with the charging base and will allow the buttons to function normally again.

Strumenti

  1. hSBPtw2P3aHxQayB
    hSBPtw2P3aHxQayB
    SpqOqJrXJkZ2TQVq
    • Pull the head from toothbrush.

  2. GJTDIFxNiXi6hJ4w
    GJTDIFxNiXi6hJ4w
    ccOgVvsUKikQLmWD
    • Use a nylon spudger to pry the chrome cap at the bottom off.

    Cover the toothbrush with a thin towel or some cardboard, then take a pair of pliers or channel locks and squeeze the corners to slightly deform the case. That will give you some room to get under the cap.

    Maybe Dave -

  3. cCIXojvXuUG5oMYW
    • Use a nylon spudger to release the black tabs on either side of internals.

    This is the most difficult part but it can be done once one understands how the tabs that need to be unlocked are designed and located. The difficulty is in seeing the tabs -- they are black - and especially the way they lock in, on the body.

    There are two tabs - one each side - built on the internal frame holding the battery and electronic circuitry. They are pushing towards the outside, and each locks inside a recessed hole on the internal side of the toothbrush body.

    They are most effectively unlocked by going deeper with the spudger and unlocking them by going behind them and hooking them from below, going in from the top opening. IMPORTANT NOTE The tabs need to be PUSHED from the outside TOWARDS the inside of the unit, i.e. towards the chassis that holds the battery and electronics. Trying to pushing the external toothbrush shaft from above will only damage the mechanism. The only way - on this latest Sonicare model- is to unlock these two black tabs.

    MASINARI -

  4. unIaqLkqKHkYYuNK
    unIaqLkqKHkYYuNK
    6scg6VwPWZayljSP
    • Put the metal head on a solid surface with handle perpendicular to the surface. Firmly, yet gently, push down until the internals start to slide out.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Zachary Bertrand

Membro da: 20/11/17

813 Reputazione

0 commenti