Razer BlackShark V2 USB Sound Card USB Cable Replacement

Scritto Da: Jalal Gibson
  • Commenti: 0
Razer BlackShark V2 USB Sound Card USB Cable Replacement

Difficoltà

Difficult

Passi

3

Tempo Necessario

20 - 40 minuti

Introduzione

If choppy, interrupted, or no audio is being transferred between your device and your Razer BlackShark V2 headset while the USB sound card is in use and your the sound card does not light up, your sound card’s USB cable is likely damaged (to confirm diagnoses & solutions, see Razer BlackShark V2 Troubleshooting Page, "Audio Cutting Out," “No Audio at All,” "Loose or Cracked Sound Card Jack"). This guide will assist you in the replacement of this component. Be mindful to not adversely snap any plastic components or small wires when applying pressure.

  1. ieGPHZJprGtUDW1J

    • Microwave the iOpener for 30 seconds

    • The iOpener can get very hot.

    • Wrap the iOpener around the sound card along the parting line and hold to help weaken the adhesive joining the halves.

  2. uVgdeacUV32GIdYg
    uVgdeacUV32GIdYg
    uEgIl4bC4Ds3qiIO

    • Separate the two halves of the plastic shell of the sound card along the parting line.

    • Using a sharp tool to saw away stubborn adhesive may be necessary.

    • Use standard caution when using sharp tools! Never cut, stab, or wedge towards your body or fingers.

  3. D24fXlwmVTkdj2EN
    D24fXlwmVTkdj2EN
    yXkJglEWFybvkQdP

    • Locate the four wires coming out of the USB cable and attaching to the circuit board.

    • Desolder these wires to remove the cable.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Jalal Gibson

Membro da: 08/03/23

277 Reputazione

0 commenti