Introduzione
This guide will help you replace a faulty or broken trigger switch assembly that may be on this Ridgid GEN5X R8653 circular saw. The switch is a critical component of this power saw. The symptom of a faulty trigger switch is failure of the saw to operate even with a fully charged battery in good condition . For further information check out our troubleshooting page. Please be sure to take all of the precautionary steps to ensure your safety while working on this device.
Ricambi
-
-
Remove the supplied Allen wrench from it's nesting space in the front of the handle.
-
Remove one 7mm T20 torx screw to remove cut depth lever located behind the motor shroud on the left side of the saw.
-
Slowly remove lever from saw ensuring not to lose the compression spring between the lever and retaining screw.
-
-
-
Loosen the angle cut guide lever by pulling it counter clockwise and tilt the base assembly to allow easy access to all housing assembly screws.
-
-
-
Remove six T20 Torx 20mm screws from the upper housing.
-
Remove three T20 Torx 32mm screws from the upper housing
-
-
-
Remove the Phillips #2 screw holding the switch assembly to the lower housing.
-
Remove the four Phillips #2 screws that hold the wires onto the switch.
-
Lift the switch out from the casing.
-
To reassemble your device, follow these instructions in reverse order.
2 commenti
The electromagnetic wave spectrum of satellite sensors necessary for successful agricultural activity is not technically implemented, after determining the goals of the business, <a href="https://dragonflyaerospace.com/remote-se..." rel="dofollow ugc">importance of remote sensing in agriculture</a>.
The electromagnetic wave spectrum of satellite sensors necessary for successful agricultural activity is not technically implemented, after determining the goals of the business, importance of remote sensing in agriculture.