Ridgid R860054 Disassembly

Scritto Da: gage.anastasio
  • Commenti: 0
Ridgid R860054 Disassembly

Difficoltà

Moderate

Passi

4

Tempo Necessario

5 minuti

Introduzione

This guide will show you how to completely disassemble your Ridgid R860054 drill.

If you are using this guide to assist with a repair, we recommend checking out our troubleshooting guide. There you may find a guide that is more specific to your needs.

Make sure to remove the battery from the drill before beginning the tear down.

  1. EMPjkoFDt12nJ6Tx
    EMPjkoFDt12nJ6Tx
    5HsGIHhKto3Z4fUf

    • Using a T10 Torx security bit, remove the ten screws from the housing assembly.

    • All of the casing screws are the same length and require the same bit.

  2. gPmTF2joe1JfuJRa
    gPmTF2joe1JfuJRa
    Sq4uHVlSF1ZQQPLs

    • Separate one half of the drill casing from the other by gently pulling both halves apart.

    • Once one half of the casing is removed, be careful! If the components are directed towards the ground, they could fall out.

  3. J3drUKVEuxsLMJqS
    J3drUKVEuxsLMJqS
    Ex652CQVLvHkpZlO
    5xROgE6JPptAPlvi

    • Remove the plastic speed switch and forward/reverse switch by softly lifting them from the casing.

    • Remove the internal components of the drill by lightly pulling on the drill chuck.

    • All of the other electronic components are attached to the chuck, and will come out with it.

  4. Vhw6nwxcLgAFQVFI

    • The main section of the drill should have the trigger, light indicator, and battery prongs all connected via wire. There should be two plastic switches separated from the rest of the body.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

gage.anastasio

Membro da: 15/03/23

339 Reputazione

0 commenti