Introduzione

Follow this guide to remove the right-side cover of a Mi-T-M heater model MH-0190-0M10.

This is a prerequisite-only guide! This guide is part of another procedure and is not meant to be used alone.

  1. YRbIqSAM36IanG1s
    YRbIqSAM36IanG1s
    YiwWQ4jHxTGCAfbx
    • Power off the machine at least one hour prior to starting repairs. Ensure the machine is completely cool to the touch.

    • Flip the power switch into the OFF position.

    • Unplug any extension cords from the included power cord.

  2. BCnDXObnU4aLlUnw
    BCnDXObnU4aLlUnw
    FLPeVeegkam51uFt
    • Use a 5/16 inch socket or Phillips screwdriver to remove the eight screws securing the upper shell, four on each side.

  3. g3goHXdvbgJkfYnr
    g3goHXdvbgJkfYnr
    kk5TiRy4kNpsgEAK
    • Lift the upper shell straight up off of the machine to remove it.

  4. QgXOps5UNWMx26Kw
    • Use a 5/16 inch socket or Phillips screwdriver to remove the four bolts securing the right-side cover.

  5. uqNbUREyKHZtrCZZ
    uqNbUREyKHZtrCZZ
    At6qgsDHeHEERmKO
    eBoB3rmIPhOQgVco
    • Tilt the right-side cover down to access the PCB board.

    • Do not fully remove the right-side cover, it is still attached via the on/off switch.

    • During reassembly, ensure the display window is aligned with the LCD display before you press the cover into place.

  6. dQqwMw1xAdemtLct
    dQqwMw1xAdemtLct
    MlXd6KO1SdtlEVpa
    EI3O1ZuBfSuFHOOL
    • There are two wires connecting the power switch to the main PCB assembly.

    • Use needle nose pliers to remove the wire with the blue connector.

    • Remove the wire with the clear connector.

    • Remove the right-side cover.

    • During reassembly, install the power switch wires back in their original locations with the blue wire above the clear wire.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Sam Omiotek

Membro da: 25/02/19

71915 Reputazione

0 commenti