Rotor Riot Mainboard Replacement

Scritto Da: Adriana Zwink
  • Commenti: 0
Rotor Riot Mainboard Replacement

Difficoltà

Moderate

Passi

10

Tempo Necessario

10 - 20 minuti

Introduzione

This is a prerequisite-only guide! This guide is part of another procedure and is not meant to be used alone.

Use this guide to remove the mainboard in a Rotor Riot controller.

  1. FxLCVbZib54VQWKy
    FxLCVbZib54VQWKy
    1sFSyKMOJbPKKROp
    VEDWjCh3FUuufMGh

    • Use your fingers to remove the screw on the back side of the controller securing the iPhone mount.

    • Remove the iPhone mount.

  2. PVXhvYfdsaFXIROD

    • Use a T6 Torx screwdriver to remove the eight 9.2 mm-long screws securing the back cover.

    • Don't try to remove the back cover all the way yet! It's still connected to the mainboard.

  3. xdUAIoqYi6B4Vcbh
    xdUAIoqYi6B4Vcbh
    QpEAThsCEAYLEMTx
    XQwDRLRGoRQrIV1H

    • Lift up the back cover of the controller.

    • Lift the back cover to a 45 degree angle and place it next to the controller.

    • Don't strain the interconnect cable during this procedure.

  4. XIR3TWivXMtfwZyi
    XIR3TWivXMtfwZyi
    cELXgbA3mvWoxqyM
    YPTYmwrhxHBeI4FW

    • Use a spudger to disconnect the phone connector cable from the mainboard.

  5. RiOomcj5houAUciq

    • Remove the back cover.

  6. 5QErktm3nfWJ2BLP
    5QErktm3nfWJ2BLP
    4KJWdfclCNLmflXZ

    • Remove the shoulder buttons by lifting them out of the case.

  7. ueMr214YcTKQupAy

    • Use a Phillips screwdriver to remove the four 7.0 mm-long screws securing the mainboard.

  8. J1r1uk4aQUPTdBHH
    J1r1uk4aQUPTdBHH
    TqeJ4fQiPn4GZhLC
    3gArViTfDNYMTjgK

    • Flip over the mainboard and place it above the controller housing.

    • Avoid tensioning the trigger button cables during this procedure and don't try to remove the mainboard all the way yet! It is still connected to the controller housing.

  9. JFnX1uNZi66CO2Ni
    JFnX1uNZi66CO2Ni
    LiHfDLtHpNSTguZe
    wKFnMKYvWpGeDUEm

    • Use a pair of blunt nose tweezers to remove the left trigger button from the controller housing by lifting it straight out of its recess.

    • Repeat this procedure for the right trigger button.

  10. SWsKqlhQUrDRveYa

    • Remove the mainboard from the housing.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Ask our Answers community for help.

Autore

Adriana Zwink

Membro da: 18/12/19

47656 Reputazione

0 commenti