Ryobi D620H Mode Selector Switch Replacement

Scritto Da: Jacob da Ponte
  • Commenti: 0
Ryobi D620H Mode Selector Switch Replacement

Difficoltà

Moderate

Passi

4

Tempo Necessario

15 - 30 minuti

Introduzione

Safety:

For your safety, ensure the Ryobi D620H Hammer Drill is not connected to any power source before you perform any repairs.

Before reassembly

While wearing disposable nitrile gloves, apply grease all around the mode shift button before reinserting it into the drill's motor assembly. This allows the mode shift button to slide easily when changing modes.

  1. V12ufqLFBXRJ1vYV

    • All nine 16mm long Torx20 screws (Circled in red).

    • Turn the screwdriver counterclockwise to loosen the screws.

    • Remove all nine screws completely.

    • Place in parts tray (Optional)

  2. V1HYuTT3Nq2FATho
    V1HYuTT3Nq2FATho
    NhXq2DepdGSQqVxj

    • Pry the right side of the case off to expose the internal components.

  3. 2R6fGFiBE6JKAiRb

    • The mode selector switch (Circled in red) once the right side case is removed.

    • Before disassembling, the mode shift button is visible on the top of the case.

  4. OFqI6K5rEOSZIWCv
    OFqI6K5rEOSZIWCv
    4Nmmi6TbVWiMmZUa
    RWvUcY6j1HOfIMue

    • Push the mode selector switch up (away from the work surface) to dislodge it.

    • Lift the mode selector switch out of its slot.

Conclusione

To reassemble your device, place the mode shift button in the slot it was removed from at a slight angle and straighten it out as you push it into place.

Congratulations, you have replaced the mode shift button on your Ryobi hammer drill!

Autore

Jacob da Ponte

Membro da: 30/10/23

469 Reputazione

0 commenti