Ryobi P235 Trigger Replacement

Scritto Da: Paul Sousa
  • Commenti: 2
Ryobi P235 Trigger Replacement

Difficoltà

Difficult

Passi

7

Tempo Necessario

30 minuti - 1 ora

Introduzione

Use this guide to replace the trigger assembly in your Ryobi P235 Impact driver if power isn’t getting to the motor while using a fully charged battery.

The trigger assembly is what regulates how much power gets to the motor and what direction the motor spins.

When you reach step 7 and 8, the wires are soldered to the motor so a soldering iron will need to be used to disconnect them from the old trigger assembly and then reattach them to the new one.

  1. 5SLxTbksiTQW6LnR
    5SLxTbksiTQW6LnR
    OtRQ5FKLNPVREGaJ

    • Push in both push tabs on the battery at the same time.

    • They are located below the green housing and are in the middle on both sides of the battery.

  2. XCyPZM6jqZheLVvU
    XCyPZM6jqZheLVvU
    cUkgQvhohIRjxSdE

    • Pull the battery away from the drill housing while holding in both tabs.

  3. 3NqpirmYgsADIUbQ
    3NqpirmYgsADIUbQ
    uB2eLNkLQZcJmhuK

    • Use a Phillips #2 screwdriver to remove the eight 16 mm screws that secure the housing.

    On my P235AVN, these screws have Torx T-10 heads.

    Rich Morin -

  4. aeN3lewWoVtBJgWZ
    aeN3lewWoVtBJgWZ
    gtHkol2cPYP6HWZO

    • Use a T20 Torx screwdriver to remove the four 25.4 mm screws that secure the front of the housing.

  5. Qn1crLmQdTZZQypU
    Qn1crLmQdTZZQypU
    iD4PylKRvCXSWCaf

    • Open the housing with the data label facing up.

  6. hVwJ1ZlpbJihG2hU
    hVwJ1ZlpbJihG2hU
    bYm1YGZ2WrwjClLb

    • Lift the trigger mechanism and other internal components out of the housing assembly.

  7. aXLBwWkuEXXgfLRx
    aXLBwWkuEXXgfLRx
    SGS11ugVGftpgkFV
    1lxhNSyEbAQBiPnx

    • Use a soldering iron to remove the black and red wires connecting the trigger assembly to the motor.

    • Use the soldering iron to connect the new trigger assembly to the motor.

    • Make sure the red wire connects to the lead with the red mark on it.

Conclusione

To reassemble your device, follow these instructions in reverse order starting at step 6.

Autore

Paul Sousa

Membro da: 29/10/19

805 Reputazione

Un commento

Is the trigger what makes this a brushless motor? Is it possible for the trigger to cause the battery to drain down completely overnight?

Netgazer -