Ryobi RJ1861V Saw Bar Assembly Replacement

Scritto Da: Ryan Quinlivan
  • Commenti: 0
Ryobi RJ1861V Saw Bar Assembly Replacement

Difficoltà

Moderate

Passi

7

Tempo Necessario

10 - 20 minuti

Introduzione

This guide demonstrates how to remove and replace the saw bar assembly in a Ryobi RJ1861V reciprocating saw.

  1. LEHPKoDNSTUXayVV

    • Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

  2. SXn4QdKkiJMOKW2K
    SXn4QdKkiJMOKW2K
    AQFdX2f1YrpKQEZl

    • Remove the rubber sleeve.

    • You may have to use some force as it has a tight fit.

  3. wudpn1SWV2ZQDoV5

    • Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

  4. VqrvDlSUhOoSFfQL

    • Use a Torx T5 screwdriver to remove the four screws on the top of the gear case.

    • There are two screws on each side of the device.

  5. qmeuqKYmCq2yI5Ff

    • Remove the backside panel.

  6. BEbOjI3g1NoHFqRK

    • Unscrew the four T5 Torx screws that hold the assembly bar in place.

  7. qZA3D3WJBtyyggAE

    • Lift the assembly bar up and out of the chassis.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Ryan Quinlivan

Membro da: 08/04/19

306 Reputazione

0 commenti