Introduzione
Use this guide to replace the rear-facing camera assembly in your Samsung Galaxy Note II.
Strumenti
Ricambi
- 
                  
                  
- 
            
Pry with a plastic opening tool, or your fingernail, in the divot to the left of the rear-facing camera, near the power button.
 
 - 
            
 - 
                  
                  
- 
            
If you have an SD card inserted, use the flat end of a spudger, or your fingernail, to press the microSD card slightly deeper into its slot until you hear a click.
 - 
            
After the click, release the card and it will pop out of its slot.
 - 
            
Remove the microSD card.
 
 - 
            
 - 
                  
                  
- 
            
Insert a plastic opening tool, or your finger, into the notch of the battery compartment and lift the battery upward.
 
 - 
            
 - 
                  
                  
- 
            
Insert your plastic opening tool between the midframe and front panel assembly on the side of the phone.
 - 
            
Slide the plastic opening tool down the seam.
 
 - 
            
 - 
                  
                  
- 
            
Push the plastic opening tool down to free the corner of the midframe from the display assembly.
 
 - 
            
 - 
                  
                  
- 
            
Free the clips along the power button side of the phone.
 - 
            
Lastly, free the two clips along the top and bottom edge of battery compartment.
 
 - 
            
 - 
                  
                  
- 
            
Use a spudger to disconnect the vibrator/power button assembly cable connector.
 - 
            
Disconnect the antenna cable connector.
 - 
            
Disconnect the display cable connector.
 
 - 
            
 - 
                  
                  
- 
            
Disconnect the front-facing camera cable connector.
 - 
            
Disconnect the headphone jack cable connector.
 - 
            
Disconnect the digitizer cable connector.
 
 - 
            
 - 
                  
                  
- 
            
Use the spudger to disconnect the antenna cable connector from the motherboard.
 - 
            
Disconnect the soft button cable connector.
 - 
            
Disconnect the USB board cable connector.
 
 - 
            
 
To reassemble your device, follow these instructions in reverse order.