Introduzione
Use this guide to remove or replace your motherboard.
Strumenti
- 
                  
                  
- 
            
Pry with a plastic opening tool, or your fingernail, in the divot to the right of the rear-facing camera, near the volume rocker.
 
 - 
            
 - 
                  
                  
- 
            
Insert your finger in the notch of the battery compartment.
 - 
            
Press the battery toward the rear facing camera while pulling outward.
 
 - 
            
 - 
                  
                  
- 
            
Use the flat end of a spudger, or your fingernail, to press the microSD card slightly deeper into its slot until you hear a click.
 - 
            
After the click, release the card and it will pop out of its slot.
 
 - 
            
 - 
                  
                  
- 
            
Use a plastic opening tool, or your fingernail, to push the SIM card out of its compartment.
 
 - 
            
 - 
                  
                  
- 
            
Insert your plastic opening tool to the left of the power button between the midframe and the front panel assembly and pry.
 
 - 
            
 - 
                  
                  
- 
            
Insert your plastic opening tool to the left of the headphone jack between the midframe and the display assembly.
 - 
            
Slide the opening tool along the top edge of the phone.
 - 
            
Continue to run the plastic opening tool around the perimeter of the phone until the midframe is separated.
 
 - 
            
 - 
                  
                  
- 
            
Use a spudger to disconnect the front-facing camera assembly cable connector.
 - 
            
Disconnect the headphone jack/earpiece speaker assembly cable connector.
 - 
            
Disconnect the digitizer cable connector.
 
 - 
            
 - 
                  
                  
- 
            
Disconnect the soft button cable connector with the flat end of a spudger.
 - 
            
Use a spudger to disconnect the USB board cable connector.
 - 
            
Disconnect the antenna cable connector.
 
 - 
            
 - 
                  
                  
- 
            
Remove the two 3.4 mm Phillips #00 screws securing the motherboard to the display assembly.
 
 - 
            
 - 
                  
                  
- 
            
Use a plastic opening tool to flip the release tab on the rear-facing camera cable ZIF connector.
 
 - 
            
 - 
                  
                  
- 
            
Slide the tip of a spudger under the rear-facing camera cable to slide it out of the ZIF connector and free it from the light adhesive.
 
 - 
            
 
To reassemble your device, follow these instructions in reverse order.
4 commenti
from where I can get the motherboard for Samsung Galaxy note 3???
abdom911 -
Can You Assist Me where can I purchase samsung GT- N7000 mother board. GALAXY NOTE 1
i need note 7000 motherboard