Samsung Galaxy S III microSD Card Replacement

Scritto Da: Walter Galan
  • Commenti: 1
Samsung Galaxy S III microSD Card Replacement

Difficoltà

Easy

Passi

9

Tempo Necessario

2 minuti

Introduzione

Use this guide to replace the microSD card.

  1. DwHxEdBbWNKViZrf
    DwHxEdBbWNKViZrf
    oBKb6GRWHcAY4hkg

    • The following four steps can be accomplished without a plastic opening tool. However, it's recommended to use a tool to best avoid breaking any clips along the perimeter of the rear case.

    • Insert a plastic opening tool or fingernail into the notch in the gap between the rear case and the rest of the phone, located at the top of the device.

    • Gently twist the opening tool to disconnect the clips securing the top of the rear case.

  2. N2d46fEShI6YEWJu
    N2d46fEShI6YEWJu
    DOQTTgHWTeMZfEKL

    • Slide the plastic opening tool left along the top edge and repeat the twisting motion to widen the gap between the rear case and the phone.

  3. 6DLNQL4LPjTVyFtj
    6DLNQL4LPjTVyFtj
    hWXD5cvEQV2RsKmi

    • Continue to move the plastic opening tool around the perimeter of the top left corner, gently prying up along the rear case.

  4. 2AQMAZmcDjGNFNAR
    2AQMAZmcDjGNFNAR
    KFWOeW64cAlgiDLc

    • Pry along the top right side, and continue prying down the right side of the rear case.

  5. OK5HBh12pNPKIlWL
    OK5HBh12pNPKIlWL
    fxVFrPQOr2nEVMT5

    • Lift up and remove the rear case from the phone.

    • You may need to peel the case up to separate it from any clips still holding it to the bottom of the phone.

    very easy to follow instructions clear and concise

    Deric JONES -

  6. RGYnKIYhRMdNHy3M
    RGYnKIYhRMdNHy3M
    hC1SLlMLkvHQVxv6

    • This step can be accomplished without the need of a plastic opening tool. Just use your finger if you want to.

    • Wedge a plastic opening tool into the small notch above the battery.

    • Pry the battery up out of its recess.

  7. 3NM1jGXSPubf4NRk
    3NM1jGXSPubf4NRk
    UtmKceXarIch4VDY

    • Remove the battery.

  8. eTAJlOLpXaaLyc3e
    eTAJlOLpXaaLyc3e
    Ls2gVFojjYjVNkwr
    GNnBuJbtURtYdo4P

    • Using your fingernail, push the microSD card slightly deeper into its slot, until you hear a click.

    • After the click, release the card and it will pop out of its slot.

    • For reassembly, push the microSD card into the slot until it clicks in place.

  9. uMMNmZkT6dihWPNE
    uMMNmZkT6dihWPNE
    DmVWXpgTkGKDFalU

    • Use your thumb to slide the microSD card out of the slot.

    • Remove the microSD card from the phone.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Walter Galan

693768 Reputazione

0 commenti