Scollegamento batteria

Scritto Da: Jeff Suovanen
  • Commenti: 25
Scollegamento batteria

Difficoltà

Moderato

Passi

6

Tempo Necessario

Nessuna stima

Introduzione

Guida solo prerequisita per scollegare la batteria.

  1. d4dlLhKy4BBopKMR
    d4dlLhKy4BBopKMR
    k2WqKJVEtDes4Ca2

    • Svita le otto viti Torx T5 da 4 mm dalla copertura inferiore.

    Missing a step about removing the tiny Phillips head screw under the XPS flip up cover in the middle. Also, there are hooks all the way around the cover so it doesn’t simply lift off.

    curtis_p_brown -

    What about step 3???

    Peter Hecht -

    Please dont hurry , take your Time to follow this procedure. It takes 20 min (not 5) and step 4 requires half of this Time. Good luck.

    Peter Hecht -

    +1 Peter Hecht is right - getting the little clips the back is snapped on with is time consuming and a bit fiddly for people not used to “spudging” off covers. Starting from the back is the key those come loose much easier and help with the rest

    Doug Steinschneider -

  2. 2TNJ3aF1OiC3dQrY
    2TNJ3aF1OiC3dQrY
    RKMGHiGBGvwUs2b6

    • Usa uno strumento di apertura in plastica per aprire l'"aletta" nel centro.

    No flap or screw on the XPS 9370, just a press-fit latch at the centre of the cover. This can be gently prised off.

    Alan Thomas -

  3. TtZb5DNBruSpJQiH

    • Svita la vite a croce Phillips nascosta sotto l'aletta.

    XPS 13 9370 doesn't have it.

    Kes Bond -

  4. SV3vQLxNPuaLAJc2

    • Usa dei plettri o uno strumento per fare leva in plastica per rilasciare i ganci della copertura, iniziando dal bordo posteriore.

    It’s not that easy to lift actually, cause there are latches. Had t release them gently all around beforehand.

    Davit Barbakadze -

    Also there’s one additional screw under that plate on the bottom!

    Davit Barbakadze -

    Maybe the later models are different, since it should be from the front: https://www.youtube.com/watch?v=xFIE2SKs...

    shigmas -

    Very difficult step, Proceed very carefull

    Peter Hecht -

    If you are replacing the battery of a 9360 or latter (2016 onward) make sure to do the FRONT first. There are latches on the back that you may break if you try to force it open that way. After prying up the front and the sides, just lift up the front like you would open a hinged box. You shouldn’t feel that much resistance as the back hinges off towards you after you’ve lifted it around 30-40 degrees.

    Giacomo P -

    Very easy with XPS 13 9370 - just used my nails (rather short!)

    Kes Bond -

  5. SclHTlmfKvgauUBi

    • Rimuovi la copertura inferiore.

    good evening, is there a site that sells the back part because it's broken

    marios cocka -

    good evening, is there a site that sells the

    back part because it's broken

    marios cocka -

  6. PyUToIwsQDJBe6OD
    PyUToIwsQDJBe6OD
    33oCi1YwifwxZYRh

    • Tira il connettore del cavo della batteria verso la batteria stessa per scollegarlo dalla sua presa.

    • Se il connettore è incastrato, spingilo un po' da un lato, poi spingi l'altro, per "guidarlo" fuori dalla presa.

    • Se hai dei problemi a guidare il connettore fuori dalla presa, usa la punta di uno spudger per spingere delicatamente sull'indentazione del connettore per sfilarlo.

    • Non tirare verso l'alto.

    • Apri lo schermo e premi il tasto di accensione per cinque secondi per scaricare qualsiasi carica dal sistema.

    DO NOT OPEN THE DISPLAY!!! When I did, on my Dell XPS 13 9360, I cracked something in the top right corner where the power button is, and the plastic part of the button came out. I can still press it, but there is now a gap there and dust can get it.

    Asher Grossman -

    I opened they display, very carefull. No problem. Open just enough to press they button.

    Peter Hecht -

    Take care on later models. This is not a breakdown for the 9360, I learned that the hard way.

    Giacomo P -

    Agree with Asher Grossman, open at your peril!

    James White -

    First put the bottom cover back, with 4 screws, one at each corner. Then you can safely open the display and press the button. Then close the display and take the bottom cover off again.

    Patrick Bower -

    I did not do the open display and drain the battery because I did not understand this part and I know my battery was essentially dead, hence why I ordered one. Did everything else and voila! Works perfectly!

    Terri DiChito -

    Opening the display worked fine for me, but when I closed it again, something definitely didn’t quite go right – I think it was trying to push against the missing back cover. I managed to carefully close the display by pushing against the metal corner thingy that was meant to push against the cover, and so far the laptop still seems to work, but I concur with Asher and James, be careful at least. Patrick’s suggestion sounds great if I’d seen it in time :)

    Lucas Werkmeister -

    Ich konnte den Stecker schliesslich mit Hilfe einer Plektren sehr gut entfernen. Das Display habe ich nicht geöffnet.

    Ursulina Kölbener -

    Much better to ensure the old battery is fully depleted (unplug from mains & switch on & let it expire) before you begin replacement.

    This allows you to leave the unit face down whilst you work on replacing the battery.

    duncan cresswell -

    NO PROBLEMS with lifting the main body while the laptop is upside down, to reach the power button (XPS 13 9370). Also no problems with closing.

    Kes Bond -

    I confirm Duncan Cresswell's method. Let your old battery discharge completely until your laptop turns off by itself. This does require some patience. It took longer than expected to use up the last procent of the battery but it worked.

    NeoK -

Conclusione

Per rimontare il tuo dispositivo, segui le istruzioni in ordine inverso.

Autore

Jeff Suovanen

Membro da: 06/08/13

426765 Reputazione

0 commenti