Sennheiser HD 4.50 Headband Pad Replacement

Scritto Da: Grace Singley
  • Commenti: 1
Sennheiser HD 4.50 Headband Pad Replacement

Difficoltà

Easy

Passi

3

Tempo Necessario

10 - 20 minuti

Introduzione

If the headband pad or cushion on your Sennheiser HD 4.50 headphones are worn down or damaged, use this guide for instructions on replacing it. In order to complete this repair, you will need to buy a new headband pad to replace the defective one you are removing.

  1. ZjNjR1qXWHmfIXy1
    ZjNjR1qXWHmfIXy1
    uasrUGYt64maXiS6

    • Extend the headphones by pulling the headband away from the base of the headphones.

    • Do this to both the right and left sides of the headphones.

  2. ZGSgnq5C1FFfy1xl
    ZGSgnq5C1FFfy1xl
    SBHk4JDrRZROEXWK
    q2SOQYQUArUs3vSA

    • Use a Phillips #000 screwdriver to remove the two screws on the silver piece on either edge of the headband.

    • Make sure to do this to both the right and left sides of the headphones.

    • After removing the screws, slide both silver pieces down.

  3. gCBLvayA5RhwfZCC
    gCBLvayA5RhwfZCC
    yCxwxpKRIsYa5AQH

    • Grasp the headband pad firmly with your pointer finger and thumb and gently pull the pad away from the headband until the pad is fully removed.

    • You may need to apply adhesive when sticking the replacement headband pad back to the headband.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Grace Singley

Membro da: 19/02/21

595 Reputazione

Un commento

Is there any guide on replacing the hinge that the ear cups are connected to?

Keoabetswe Morake -