Introduzione
To replace a broken wire connected to the circuit board, soldering must be done. Before attempting this guide, please read the IFixit's guide to soldering (Come saldare e dissaldare componenti elettrici). For this replacement, perform all steps on a table away from any flammable objects.
Ricambi
-
-
Using the Phillips #1 screwdriver, remove the 2mm screw located on the bottom of the device, near the hinge.
-
-
-
Using the plastic opening tools, gently pry open the side of the large panel.
-
Keeping the tool in, slowly slide the tool along the side of the panel.
-
-
-
Rotate the device 180 degrees.
-
Gently slide the plastic opening tool along the side of the panel.
-
-
-
Using both hands, slowly pull apart the back panel from the rest of the device.
-
Gently flip the back panel open so the circuit board faces up and the two panels are side by side.
-
-
-
Softly pinch the red and blue wires close to the white connector.
-
To pull the wires out, wiggle them back and forth until the connector is fully out.
-
-
-
Unscrew the three 2mm screws holding the circuit board down using a Phillips #1 screwdriver.
-
-
-
Make sure the white USB port cover on the side of the device is pulled out or you won't be able to lift the circuit board.
-
Gently lift the circuit board out of the device using tweezers.
-
-
-
Using a solder iron with a fine tip, slowly solder off the broken wire from the first connection point.
-
Repeat for other connection point of wire.
-
To reassemble your device, follow these instructions in reverse order.
