Sony Xperia XA1 Ultra Loudspeaker Replacement

Scritto Da: Jacob Jung
  • Commenti: 5
Sony Xperia XA1 Ultra Loudspeaker Replacement

Difficoltà

Easy

Passi

8

Tempo Necessario

7 minuti

Introduzione

This guide will show you how to remove the loudspeaker from your Sony Xperia XA1 Ultra. The loudspeaker needs to be replaced if sound is no longer emitted from your phone. A heat gun or hairdryer is needed to open the back panel, which can become hot and potentially damage the phone. In addition, a T5 screwdriver is needed to remove screws, and a spudger is used to lift and remove components of the phone.

  1. TNOCKQRjsismJAur
    TNOCKQRjsismJAur
    KHjIGfHLpkXUtCME

    • Wedge your finger under the bottom ridge of the SD card insert.

    • Pull outwards with your fingers to remove the SD card from the left side of device.

    How do you remove it? (Seems obvious but write for any audience, and say how to do things instead of just what to do)

    Kyle Ladtkow -

  2. ryJAIJUHscWkPGYQ

    • Use a hair dryer to heat each corner of the phone.

    • Alternate heating each corner for a minute to loosen the adhesive binding the back cover to the phone.

    • Don't heat one area for too long; the phone may get damaged from overheating.

    Consider saying “loosen” instead of “soften” so that steps 2 and 3 use the same terms. Somebody may not know that heating the glue will loosen it, and so they will be confused reading “once the adhesive is loosened” in step 3.

    Kyle Ladtkow -

  3. DGOhTBh2EenRDDff

    • Press a suction cup on a heated corner of the device.

    • Hold the phone down and gently lift the suction cup to create a small gap.

    • You may hear crunching or popping sounds when you lift up the back cover.

    sure that there is adhesive tape on backcover?

    where should it tape on at the device inside?

    looks more like only plugged together`?

    Alexander H -

  4. FODQEhCkSsrSmi4a

    • Insert your iFixit Opening Tool in the small gap between your phone and the back cover.

    • Lift up on the iFixit Opening Tool and insert your plastic card in the small gap between your phone and the back cover.

    Period missing for first point.

    Kyle Ladtkow -

  5. Wh3uglejNEpDjhfH

    • Slide your plastic card along the side of your phone to loosen the adhesive.

    • Move the card along the sides of the phone to lift all of the corners.

    Can you clarify what should be repeated in this step?

    Tiffany Dang -

  6. gs1wMw1GfHP2o1ZI

    • Lift up the back cover by lifting up the sides of the phone with your hand.

    • Apply a new strip of adhesive for reassembly.

  7. XC4YxfZVGkYVXajk

    • Remove the five 4mm T5 screws connecting the speaker to your phone.

  8. NiLlieZMUalbxHrP
    NiLlieZMUalbxHrP
    P6EvA1RCpZN6OeDI

    • Insert your iFixit Opening Tool underneath the speaker and gently lift up.

    • Once the speaker is slightly lifted, use your hands to remove the piece from the device.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Jacob Jung

Membro da: 18/04/18

1429 Reputazione

0 commenti