Sostituzione connettore batteria iPad Mini CDMA

Scritto Da: Andrew Optimus Goldheart

Commenti: 10

Sostituzione connettore batteria iPad Mini CDMA

Difficoltà

Moderato

Passi

Tempo Necessario

15 - 30 minuti

Introduzione

Prerequisito per scollegare la batteria.

Strumenti

Passo 1

Svita le tre viti a croce Phillips #00 da 1,3 mm che fissano la copertura del connettore alla scheda madre.
Assicurati di non scambiare queste tre viti con delle altre, in particolare quelle che fissano la protezione del pannello LCD alla copertura posteriore dell'iPad. Qualsiasi vite leggermente più lunga potrebbe rovinare la presa della vite, causando un danno irreparabile alla scheda madre.

Note: These three screws are smaller than the rest of the screws holding the larger LCD shield although they look similar. If you substitute the larger screws, you will pop a screw bracket which can damage the board on both the mini original and mini 2 retina. I just wrote a blog post about how this happens: http://mendonipadrehab.com/entries/gener...

jessabethany - 10/07/14

Hi jessabethany. Thank you for the warning. I read your blog post and found it to be very informative. Thanks for adding the warning to the step. It will most definitely help others avoid any damage to the logic board. Thanks!

Walter Galan - 15/07/14

Be careful: At iPad mini retina Wi-Fi there are thw short and one longer screw! Don't mix them!

sandro - 24/11/14

Passo 2

Usa un paio di pinzette per rimuovere la copertura del connettore dall'iPad.

Passo 3

Usa uno strumenti di apertura in plastica per fare leva e sollevare delicatamente il connettore dalla sua presa sulla scheda madre.
Stai molto attento a fare leva sul connettore della batteria e non sulla presa. Se fai leva sulla presa sulla scheda madre, potresti danneggiare l'intero connettore.

Make sure you disconnect the battery. If not and ipad is still on you can have problems with the LCD backlight. To fix that problem you have to solder

Mattis -

I may be experiencing the backlight problem you mentioned. What connection needs to be soldered?

Grillwrecka -

Have an issue - heard that if you don't disconnect the battery a fuse is blown. I need help to fix the blown fuse.

Andrew Kivell - 27/03/15

There is an extensive thread in Answers about iPad mini backlight problems.Th screen stays black after a digitizer replacement.

jessabethany - 27/03/15

After unplugging the battery place a guitar pick in-between the two connections.

While continuing to work on the iPad you may inadvertently cause the two connections to touch.

Michael Vovaris - 08/07/15

Yeah, you need to put the pick in between the connections so the battery doesn't touch the logic board connector and blow a fuse and make your backlight not turn on. You really don't want to have to solder the 2 connections together, especially if you don't know how, like me! I will use your comment's advice when working.

WolfyHD - 20/07/17