Sostituzione della scocca anteriore PSP 1000

Scritto Da: Henry Lee

Commenti: 13

Sostituzione della scocca anteriore PSP 1000

Difficoltà

Facile

Passi

Tempo Necessario

10 minuti

Introduzione

Questa guida ti mostrerà come rimuovere la scocca/cornice della PSP.

Strumenti

Phillips #00 Screwdriver

Passo 1

Capovolgi la PSP in modo tale da avere il retro davanti a te.

Passo 2

Cerca il bottone del coperchio della batteria a sinistra sul retro della PSP.
Premi il bottone e rimuovi il coperchio.

You are dumbbb... BRO YOUR DUMB BC U DIDNT HAVE TO USE A TOOL TO OPEN THE DOOR. USE YOUR FINGER""

Paulo Moments -

The battery door can be damaged dont use a tool

Paulo Moments -

That also happend to me it got destroyed by screwdriver

Paulo Moments -

Passo 3

Usando un dito, rimuovi la batteria tenendo la console come mostrato nell'immagine.

The use of the opening tool is completely unnecessary. There is a finger actuated opening latch button that says “PUSH” on it. Simply press down with your thumb then slide your thumb down and away, dragining the battery door with it. It will then come off. Assuming the system still has its original plastics, they may have become brittle enough that the opening tool could damage the release button or the plastic cover.

Franklin Allen -

Passo 4

Rimuovi le quattro viti indicate con un cacciavite a croce di dimensioni #00.
Dovrai staccare lo sticker di garanzia per accedere alla vite nell'angolo inferiore sinistro.

Much luck to you if you have a tiny, metal screwdriver like I did, the screws might be stuck in there and may require some force.

Squib - 14/08/17

you need to peel back the warranty sticker in order to access both the lower left and lower left screws

Frederick zzstu Geib - 18/03/20

This is a bit misleading, you should only remove the two black screws in the battery compartment. The silver ones can stay.

Damian Cartwright - 21/10/20

The two left hand screws won’t come out of mine

XULF -

iFixit screwdriver bits aren't thin enough to reach the two screws on the right near the memory stick slot.

Fliggle_Slaps -

Can't edit previous comment so here's a new one:

Standard or older iFixit screwdriver bits aren't thin enough to reach the two screws on the right near the memory stick slot. You'll need precision bits that have longer tips to reach these deep screws.

Fliggle_Slaps -