Introduzione

Guida prerequisita per sostituire la scheda madre di un Samsung Galaxy S4.

Strumenti

  1. QOBJ3LFbWBFVVGcA
    QOBJ3LFbWBFVVGcA
    yVD1EFNFEaXchvOf
    63C2pIomgcyGqkCc
    • Usa l'estremità piatta di uno spudger per staccare il connettore della scheda USB.

    • Scollega il connettore del cavo della fotocamera anteriore.

    • Stacca il connettore del cavo del gruppo altoparlante voce.

  2. rNPnmChVeydDDOkQ
    rNPnmChVeydDDOkQ
    XLIVIYF1GdMvaGRN
    epVsggkyQGhUiBBG
    • Scollega il connettore del gruppo del jack cuffie.

    • Stacca il connettore del cavo del display/digitizer.

    • Scollega il connettore del cavo dell'antenna.

    My model had an antenna connection next to the usb board connector in addition to the antenna connection near the display cable connector.

    Drew -

    That's point a, on the daughter board (where the USB is located is point b. You must connect it from a to b

    djweijers1997 -

    I could not get the screen connector to fit on with the motherboard assembly in place. I had to remove the motherboard assembly, attach the screen connector, and then carefully replace the motherboard assembly, with the screen connector still attached..

    Tom4G -

    Same as Tom4G above. When trying to connect the screen connector, it would not give me that nice clear snap indicating a positive connection. The phone powered up with no screen. So, I disconnected the other connectors again, lifted the motherboard out and connected the screen connector by pinching it with finger and thumb from both sides of the motherboard, this time getting a nice snap when it engaged.

    speedrzr -

  3. rj6NCBPKbIQYnvFu
    • Rimuovi la singola vite Phillips #00 da 2,4 mm dal gruppo della scheda madre.

    As Sam Lionheart states at the end of this guide, some of these phones have an additional antenna on the opposite side of the phone. Be sure to detach it before removing the motherboard.

    mcr4u2 -

  4. aePe63fVSmTOtsPY
    aePe63fVSmTOtsPY
    etpnFuSt2fSS2A1Y
    • Rimuovi con cautela la scheda madre.

    • Tieni la scheda madre dai bordi per evitare danni da elettricità statica. Stai attento a non impigliarti nei cavi mentre la estrai dal gruppo display.

Conclusione

Per rimontare il tuo dispositivo, segui queste istruzioni in ordine inverso.

Sam Goldheart

Membro da: 19/10/12

465140 Reputazione

0 commenti