SteelSeries Arctis Pro Plus GameDAC 3.5mm Headphone Jack Replacement

Scritto Da: Juan Gonzalez
  • Commenti: 3
SteelSeries Arctis Pro Plus GameDAC 3.5mm Headphone Jack Replacement

Difficoltà

Difficult

Passi

6

Tempo Necessario

25 - 35 minuti

Introduzione

If the headphone jack is damaged or the headset is not longer outputting sound, you might need to replace the 3.5mm audio jack. Follow this guide to safely access and remove the audio jack.

  1. IKkQjrpL4TkdZ1EV
    IKkQjrpL4TkdZ1EV
    ponYSGg4OAy6DxxJ

    • Lift the edge of the cushion and slightly pull out.

    • Work your way around the cushion until it comes off.

    • Repeat for the other cushion.

  2. owGDSUOB3qFV6UDd

    • Remove the three 5mm screws with a Phillips #0 driver head on the headphone with the microphone.

    I opened my Arctis 7's open and I accidentally dropped some screws. Now my headset is loose. I need to know what specific screws are they and where I can get them. And my volume wheel is loose aswell. I dont know what to do.

    John -

  3. YNRUNnAfOAHgn2xt

    • Lift the speaker off the headset to expose the circuit board.

    • Be careful not to lift the speaker too quickly or too forcefully to prevent the wires from being pulled out of their connections.

  4. 34uoLBYLkyTFCUEa

    • Remove the three 5mm screws using a Phillips #0 driver head.

  5. JatiTFvqTI6AWGqM

    • Lift the circuit board out of the plastic housing.

    • Press in on the volume wheel while pulling on the circuit board to help maneuver the circuit board out of the housing.

    I have the basic arctis 5 model and the circuit won't come loose. It feels as if there is a pivot point right where the volume potentiometer is. Any tips?

    Mircea -

  6. QbsnFkFhGpKIS2XZ
    QbsnFkFhGpKIS2XZ
    npBZnmpjVsCWR4Gj

    • Desolder the three connecting audio jack leads from the circuit board.

    • For help desoldering connections, follow this useful guide on Come saldare e dissaldare componenti elettrici.

    • Use caution when soldering. The heated tip may cause damage to the board or burn you.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Juan Gonzalez

Membro da: 24/01/19

422 Reputazione

Un commento

hey @juangonzal87030 I am unable to take out circuit board out of my Arctic Wireless Pro even even when all the screws are taken out. I am unable to understand what am I missing over here. Can you help

Ashutosh Kumar Singh -