SteelSeries Arctis Pro Plus GameDAC Headset Circuit Board Replacement

Scritto Da: Kyle Chang
  • Commenti: 6
SteelSeries Arctis Pro Plus GameDAC Headset Circuit Board Replacement

Difficoltà

Easy

Passi

5

Tempo Necessario

20 - 30 minuti

Introduzione

Follow this guide to access and remove the main circuit board from the headset housing.

  1. sDeg65jlUQtc4BU2
    sDeg65jlUQtc4BU2
    HVVlMrnnvsoblBNG

    • Lift the edge of the cushion and pull out slightly.

    • Work your way around the cushion until it comes off completely.

    • Repeat for the other cushion.

    I do not believe that my Arctis 7 uses Phillips #0 it looks to be some kind of tamper proof start bit, do you know what kind that would be?

    Jerrett Smith -

  2. 2CAPVHviF3OHHUKT

    • Remove the three 5mm screws with a Phillips #0 driver head on the headphone with the microphone.

    Philips #0 doesn’t work, it’s using a weird screw head

    Mojo -

  3. m13FTVZE5LlIfIfI

    • Lift the speaker off the headset to expose the circuit board.

    • Be careful not to lift the speaker too quickly or too forcefully to prevent the wires from being pulled out of their connections.

  4. QrMSlgKMI2URX4KQ

    • Remove the three 5mm screws using a Phillips #0 driver head.

  5. lSZq2UG6PIlBJBXL

    • Lift the circuit board out of the plastic housing.

    • Press in on the volume wheel while pulling on the circuit board to help maneuver the circuit board out of the housing.

    I am worried about damaging the board while lifting the board out, there is quite some resistance, do I apply more pressure?

    Garrett Chambers -

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Kyle Chang

Membro da: 24/01/19

1152 Reputazione

3 commenti

any idea where i can buy the circuit parts to both side?

erminio santiago -

any idea where i can buy Circuit Board Replacement for both side? please

erminio santiago -

What's the problem that requires circuit board replacement? My left speaker doesn't work checked and all wires connected. Wondering if the circuit board fixes that

bayarea_rooter -