Teenage Engineering OP-Z Rubber Feet Replacement

Scritto Da: Tobias Isakeit
  • Commenti: 0
Teenage Engineering OP-Z Rubber Feet Replacement

Difficoltà

Easy

Passi

6

Tempo Necessario

5 - 10 minuti

Introduzione

Use this guide to replace the rubber feet of your OP-Z.

  1. 3P3PtudTARX4VYYo
    3P3PtudTARX4VYYo
    wV3ZGSxOE1EQcKRX
    kabawgJinAQaRfXx

    • Unlock the four rubber feet by turning them 90° counterclockwise using your thumb or finger tip.

    • There is a tiny mark on every foot facing the bottom edge of the OP-Z. After turning them they should face towards the short edge where the on/off switch is.

  2. pueLJe1vTPDuZsOa
    pueLJe1vTPDuZsOa
    QbptcMmcnDwpxrCE

    • When turning the OP-Z over again the bottom plate should come off by itself (thanks gravity).

    • If the bottom plate won’t come off you might want to make sure every foot is rotated correctly and gently tug on one of them.

  3. QCjZngZMmxyi3pxU

    • Remove the bottom plate including the rubber feet.

  4. ScEcmtoiEfrICQNI

    • Remove the four Phillips #0 screws from the back of the rubber feet.

  5. taFGxxktQuL2YGhT
    taFGxxktQuL2YGhT
    jfKKI4gjmxTPayhJ

    • Separate the front and rear part of the rubber feet from the back cover.

  6. 1DGgeYITIjPHkCHt

    • When reassembling make sure to correctly align the front and rear part of the rubber feet. The notch and grove should interlock and fit into the cutout of the back cover.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Tobias Isakeit

Membro da: 31/03/14

116550 Reputazione

0 commenti