Introduzione
This guide shows how to replace the back casing of the guitar.
Strumenti
-
-
Flip the bass onto its backside, so that the strummer is facing the table and the battery compartment is facing you.
-
Use a J1 Phillips head screwdriver to remove ten 5mm short screws.
-
Use a J1 Phillips head screwdriver to remove four 5mm long screws.
-
-
-
Flip the bass to the front, with the strummer and fret buttons facing you.
-
Use a J1 Phillips head screwdriver to remove two 10mm silver, short screws.
-
-
-
Flip the bass on its back again, so that the strummer is facing down and the battery compartment is facing you.
-
Pull off the back whole panel so that the bass is now open.
-
Conclusione
To reassemble your device, follow these instructions in reverse order.
