Introduzione
In this guide you will learn how to replace the whammy bar in a Rock Band Beatles Hofner Bass.
Strumenti
- 
                  
                  
- 
            
Flip the bass onto its backside, so that the strummer is facing the table and the battery compartment is facing you.
 - 
            
Use a J1 Phillips head screwdriver to remove ten 5mm short screws.
 - 
            
Use a J1 Phillips head screwdriver to remove four 5mm long screws.
 
 - 
            
 - 
                  
                  
- 
            
Flip the bass to the front, with the strummer and fret buttons facing you.
 - 
            
Use a J1 Phillips head screwdriver to remove two 10mm silver, short screws.
 
 - 
            
 - 
                  
                  
- 
            
Flip the bass on its back again, so that the strummer is facing down and the battery compartment is facing you.
 - 
            
Pull off the back whole panel so that the bass is now open.
 
 - 
            
 - 
                  
                  
- 
            
Use a J1 Philips head screwdriver to remove one 10mm screw.
 - 
            
This will unscrew the electrical connection between the whammy bar and the blue circuit board.
 - 
            
Remove the electrical connector.
 
 - 
            
 
To reassemble your device, follow these instructions in reverse order.