VTech VM3254 Battery Replacement

Scritto Da: Jackson Meacham
  • Commenti: 2
VTech VM3254 Battery Replacement

Difficoltà

Easy

Passi

4

Tempo Necessario

5 minuti

Introduzione

If the VTech VM3245 will not switch on, the battery may need to be replaced. The information below specifically states how to remove the battery and replace it with a new one. The only tools needed include a Phillips #00 screwdriver, Jimmy, and one opening pick. You will not have any difficult steps, but remove the front cover of the device attentively.

  1. UZjjftwAtQJQfoDc
    UZjjftwAtQJQfoDc
    kMVgGOKbFxrdYDr6

    • Turn the monitor on its back, and remove the two 8 mm Phillips #0 case screws.

  2. 5eGVBwauuGiLw6JX
    5eGVBwauuGiLw6JX
    MVdSBLDoeDhIiQRH
    J2b25UanO51Fo2Vx

    • Use the iFixit Jimmy tool to begin removing the face of the monitor.

    • You may need to use an opening pick to hold the screen open as you move the Jimmy tool around all the edges of the device.

    • Once the screen has been separated, lift it from the case.

    • Be gentle while removing the screen. There are wires connected to the two pieces that may be damaged.

  3. nTKIVscntILLnkvB
    nTKIVscntILLnkvB
    HBSMJXaE2jowLQcN

    • Remove the four 8 mm Phillips #00 screws from the bracket that secures the battery.

    • Remove the bracket.

  4. pHkWCCXqqZmEeQGY
    pHkWCCXqqZmEeQGY
    vyDInWMSGWVwwH62
    PRsgCBHdRylQOFBa

    • Gently remove the battery from its location.

    • Carefully disconnect the bundled cable connector from the circuit board.

    Wo finde ich denn genau solch eine Batterie ?

    Besten Gruß

    René

    kroenung1990@googlemail.com

    René Krönung -

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Jackson Meacham

Membro da: 14/02/23

109 Reputazione

Un commento

What is the battery that needs to be replaced called?

Aden Brooks -