VTech VM3254 Camera Circuit Board Replacement

Scritto Da: Christina Block
  • Commenti: 0
VTech VM3254 Camera Circuit Board Replacement

Difficoltà

Moderate

Passi

2

Tempo Necessario

5 minuti

Introduzione

If there is no image coming from the baby monitor this could mean that circuit board need to be replaced. In order to replace the circuit board, you need a Phillips #00 Screwdriver.

  1. M4EhVe2mZq2qW54D
    M4EhVe2mZq2qW54D
    jBDyJhZEQiGLsp6K
    Gw56dPggo1VOrDmG

    • Remove the two 8 mm Phillips #00 screws from the back of the device.

    • Use the Jimmy tool to open the case.

    • You may need to use an opening pick to hold it open.

    • Remove the face from the case.

  2. Z4LAWv1TUebmTycB
    Z4LAWv1TUebmTycB
    KIPauksIun1ySHkM

    • Remove the three 8 mm Phillips #00 screws from the board.

    • Gently remove the board from the case.

    • Be careful, there are wires connecting the board to the case that could be damaged.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

Christina Block

Membro da: 10/02/23

375 Reputazione

0 commenti